Publicité
Les langues disponibles
Les langues disponibles
COMPATIBILITY:
The (A type) USB connection on the face of this unit is for connecting
*
USB storage devices such as flash drives, MP3 players and external
hard drives.
While this player is capable of connecting to and loading music from
most types of USB storage devices and MP3 players, we can not guar-
antee playback from all such devices due to the varying nature of the de-
vices and their storage methods. Most storage devices and storage
class MP3 players are compatible for playback. Check with the devices
manufacturer for additional compatibility information.
The player pre-reads the entire directory structure and locates all valid
MP3 files within those folders, thus a LARGE CAPACITY
storage device will take a LONG TIME TO LOAD.
CONSTANT BIT RATE (CBR) vs. VARIABLE BIT RATE (VBR) MP3:
Files are created (Encoded) using two basic methods , Constant Bit
Rate (CBR) and Variable Bit Rate (VBR). VBR files, while saving some
space, are decoded on-the-fly causing a slight lag or stutter when set-
ting a CUE point, and can also cause a slight skip during playback if the
units memory buffer is over run, whereas CBR files take up a little more
room but are quick to process which means no lag in CUE setting or
playback.
VBR files can easily be converted to CBR using any commercially avail-
able MP3 ripping software.
Media support types: CD, CD-R. CD-RW, USB
Media support formats: CD AUDIO, CD-MP3, and USB WAV/MP3
USB support disk format: FAT, FAT32 and NTFS
FADER REPLACEMENT:
1. UNSCREW THE FADER (B) SCREWS. DO NOT TOUCH IN-
SIDE SCREWS (C) CAREFULLY REMOVE OLD CROSS
FADER AND UNPLUG CABLE (D)
2. PLUG IN THE NEW CROSS FADER INTO CABLE (D) AND
PLACE BACK INTO MIXER.
3. SCREW THE CROSS FADER TO MIXER WITH THE FADER
PLATE SCREWS (B)
4. REPLACE THE FACE OF THE MIXER AND SCREW THE
FOUR SCREWS BACK IN AND REPLACE THE FADER
KNOBS.
SPECIFICATIONS:
GENERAL:
Type.......................................................Compact Disc Player &
Disc Type.............................................Standard Compact discs
Time Display.................................Track Elapsed, Track Remain
Variable Pitch.......................± 24% Slider with Resume Switch
Pitch Bend.......................................................................± 24-%
Maximum Instant Start...............................Within 0.03 seconds
Installation....................................................................19" each
Dimensions............... 19" x 3.5" x 10" (482.6 x 88.9 x 254 mm)
Weight.........................................Main unit: 11.35 lbs. (5.14 kg)
AUDIO SECTION:
Quantization......................1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate........................................................8 Times
Sampling Frequency.....................................................44.1 kHz
Frequency Response........................................20 Hz to 20 kHz
Total Harmonic Distortion...............................Less Than 0.05%
Signal to Noise Ratio.........................................................85 dB
Dynamic Range.................................................................85 dB
Channel Separation.............................................85 dB (1 KHz)
Power Supply........................................AC 100/240V, 60/50 Hz
INPUTS:
Phono.............................................................................3mV,47 KOhm
Line...........................................................................150 mV, 27 KOhm
MIC..............................................................1.5 mV, 1 KOhm balanced
OUTPUTS:
Max...........................................................................20V Peak-to Peak
Rec.............................................................................225 mV, 5 KOhm
SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITHOUT NO-
TICE FOR THE PURPOSE OF IMPROVEMENT.
7
CDMP-6000
USB Mp3 Reader
(12 cm & 8 cm)
Publicité
