Gemini CDMP-6000 Manuel D'instructions page 4

INTRODUCTION:
Congratulations on purchasing the Gemini CDMP-6000 CD Player.
This state of the art professional table top CD player is backed by
a 1 year warranty. Prior to use, we suggest that you carefully read
all the instructions.
FEATURES:
-
Audio CD, CD-R & Mp3 compatible
- Play files with the extensions .MP3 and .WAV
from USB memory sticks*
- BPM (TAP) Read Out
- 3 Selectable Jog modes Pitch Bend/Search/Scratch Effect
- Instant-start & cue with preview
- Single & continuous play modes
- Seamless loop with reloop
- Pitch bend via jog wheel or buttons
- Two mode time selection
- Variable pitch control with three settings +/- 8,16 & 24%
- 3-band EQ w/ Gain Control
- 1/4" headphone output
- XLR and 1/4" mic input
- Auxiliary Inputs for Phono or Line devices
SAFETY SPECIFICATIONS:
Laser Diode Properties
Material: Ga - Al - As
Wavelength: 755 - 815 nm (25° C)
Laser Output: Continuous Wave, max. 0.5 mW
PRECAUTIONS:
1. Do not use this CD player at temperatures below 41°F/5°C or
higher than 95°F/35°C.
2. The apparatus should not be exposed to dripping or splashing,
and no objects filled with liquids such as vases should be placed
on the apparatus.
3. Place the unit in a clean and dry location.
4. Do not place the unit in an unstable location.
5. When disconnecting the power cord from the AC outlet,
always grasp it by the plug. Never pull the power cord.
6. To prevent electric shock, do not remove the cover or the bot-
tom screws.
7. There are NO USER SERVICEABLE PARTS INSIDE.
Please refer to a qualified technician.
8. Do not use chemical solvents to clean the unit.
9. Keep the laser pickup clean by keeping the tray closed.
10. Keep this manual in a safe place for future reference.
IN THE USA ~ IF YOU EXPERIENCE PROBLEMS WITH THIS UNIT CALL
GEMINI CUSTOMER SERVICE AT: 1 (732) 346-0061. DO NOT ATTEMPT TO
RETURN THIS EQUIPMENT TO YOUR DEALER.
CONNECTIONS:
MAIN POWER RECEPTACLE: This is a Standard 3-prong IEC power
1
connector. Connect the detachable line cord (included in the box with
your CDMP-6000 to the power receptacle, and plug the other end of the
line cord into an AC outlet. The CDMP-6000 has a universal power sup-
ply that can accept any AC voltage from 100 VAC to 240 VAC. No need
for voltage select switches. It will work virtually anywhere in the world. It
is less susceptible to voltage sags or spikes than conventional power
supplies, providing greater electro magnetic isolation and better protec-
tion against
AC line noise.
POWER SWITCH: The POWER SWITCH turns the unit ON or OFF.
2
Make sure the switch is in the 'OFF' position prior to making any con-
nections.
GROUNDING SCREW When using (a) turntable(s), you will need to
3
ground the RCA cable(s) by screwing in the grounding fork(s) to the
GROUNDING SCREW located on the rear panel of the CDMP-6000.
MASTER XLR OUTPUT (BALANCED): Allows you to connect bal-
4
anced XLR cables to MASTER OUTPUT of the CDMP-6000 both the
RCA and XLR outputs can be used at the same time but are both con-
trolled via the same MASTER OUTPUT.
MASTER RCA OUTPUT: The MASTER RCA output connects the
5
mixer to your main amplifier using standard audio cables with
RCA-type connectors.
The RECORD RCA OUTPUT output jacks can be used to connect the
6
mixer to the record input of your recording unit, thus enabling you to
record your mix with RCA cables.
CONVERTIBLE PHONO/LINE INPUTS: The CDMP-6000 has
7
2 CONVERTIBLE (Switched) PHONO/LINE (PH/LN) RCA INPUTS.
The switches which are located to the right and left of the RCA inputs
for channels 1 and 2 allow you to choose between a PHONO
(Turntable) input or a LINE level (Mp3, CD, Tape player etc..)and re-
quire the proper switching. When switched to the PH position you may
use any Turntable with a magnetic cartridge, remember to connect your
ground wire (see GROUNDING SCREW) or there may be a system
hum.
8 MIC (MICROPHONE) INPUTS: The main MIC or Microphone inputs
are located at the back right hand corner and front middle of the CDMP-
6000 and will accept any balanced and unbalanced XLR as well a stan-
dard 1/4" connector. You can control the gain for the MICROPHONE
VOLUME rotary located on the top panel.
FUNCTIONS:
DISC TRAY: The DISC TRAY is where the CD is held during loading,
9
unloading and playback, and holds both 12 cm and 8 cm CD's.
(DO NOT FORCE THE CD TRAY TO CLOSE EXCESSIVE FORCE
WILL DAMAGE THE CD MECHANISM, USE THE OPEN AND
CLOSE BUTTONS)
EJECT BUTTON: (THE PLAYER MUST BE IN PAUSE MODE TO
10
EJECT A CD) Once PAUSED Pressing the EJECT BUTTON will
eject the CD.
4
CDMP-6000