If the night temperature is set to the "- - " position, the
appliance will remain in the standby position. The appliance
will only switch on at the next switch-on time of the day
temperature.
The appliance must be in standby position in order to be
controlled by the timer
Example of switch times
You have set a day temperature and night temperature of,
for example, 20 ºC and 15 ºC.
✹
P1
TIMER = 7 hours; the temperature will go to 20 ºC
at 7 am.
P1
TIMER = 9 hours; the temperature will go to 15 ºC
at 9 am.
✹
P2
TIMER = 17 hours; the temperature will go to 20 ºC
at 5 pm.
P2
TIMER = 22 hours; the temperature returns to 15 ºC
at 10 pm.
Setting times for the timer
To set the timer, proceed as follows:
• Set the day and night temperature as described above at
section.
• Briefly press the SET button to enter the (P*) TIMER
position.
• Press the SET button until P1
the time flashes.
• Set the first switch on time of the day temperature using
the buttons
(large flame) and
• Briefly press the SET button to set the next time of the
cycle, P1
TIMER.
• Successively set the times P2
• Press the OFF button or wait until position (P*) TIMER
appears on the display.
Activating the timer function
Follow the steps below for activating the timer control:
• Place the appliance in the standby (pilot burner) position
using button
(small flame).
• Set the day/night temperature if you have not yet done so.
✹
• Set the timer times P1
TIMER and P2
TIMER.
• Choose the (P*) TIMER function using the SET button.
Replacing the battery
If the battery is almost empty, the display will show
"BATT".
To replace the battery, proceed as follows:
• Remove the cover at the back side of the remote control.
• Disconnect the 9V block battery from / connect the 9V
block battery to the connector.
!Caution - Observe the "+" and "-" poles of the batteries
and the connector;
- Use alkaline batteries;
- Batteries are regarded as "small chemical
waste" and may therefore not be disposed with
the household rubbish.
• Place the battery in the holder.
• Replace the cover.
✹
TIMER is displayed and
small flame).
✹
TIMER and P2
TIMER.
✹
TIMER, P1
TIMER, P2
OPERATING INSTRUCTIONS
33