Télécharger Imprimer la page

Bosch ROTAK 320 Instructions D'emploi page 14

Masquer les pouces Voir aussi pour ROTAK 320:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
For products not sold in GB:
WARNING: For safety, it is essential that the
B
mains plug 4 attached to the product is fitted to the
power supply cable 14.
The couplings of connection leads must be pro-
tected against splashes and the coupling sockets on
the leads must be made of rubber or coated with
rubber.
Fixing means for the connection leads must be
used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
Products sold in GB only: Your mower is fitted with
an approved 13 A (BS 1363/A) electric plug and is
protected by a 13 A fuse (ASTA Approved to
BS 1362).
If the fitted plug is not suitable for your socket out-
lets, it should be cut off and an appropriate plug fit-
ted in its place by an authorized customer sercive
agent.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be inserted
into a 13 A socket elsewhere.
Assembly
A
Insert the handle bottom 8 into the holes provided
and
secure with the screws.
Attach the handle top 3 with the bolts and wing
nuts 13 to the handle bottom 8.
Note: The handle top 3 is height adjustable. Fix han-
dles in desired position I or II.
Note: Ensure that the cable clips supplied are used
to fix the cable to the handle.
Attach cable to cable restraint 5 ensuring that
B
sufficient cable slack is available. (non GB models)
Snap together both top and bottom half of the grass-
box.
Ensure the cables are not trapped when folding/un-
folding top handles. Do not drop the handles.
14 • F016 L70 451 • 07.01
Grassbox
D
Fitting
Lift the deflector guard 7 and hold up, fit the grass-
box 6.
Removing/Emptying
Lift the deflector guard 7 and hold up. Remove
grassbox 6.
For non grass collection the mower can be used
without the grassbox 6 in position, with the deflector
guard 7 in the down position.
Adjusting the Cutting Height
C
Stop, release switch lever and wait until
the motor stops before adjusting height.
The blades continue to rotate for a few
seconds after the machine is switched off,
a rotating blade can cause injury.
For the first cut of the season, a high cutting adjust-
ment should be selected.
Your machine has three settings that result to the
following cutting heights.
I = 20 II = 40 III = 60
Remove the grassbox to aid adjustment (see Grass-
box).
Lift the mower,
TIP: The front wheel has a height of cut indicator 12
which shows the postion of the wheels. Move this
wheel first, then repeat for each wheel 10.
Pull/push the wheel to the front of the mower us-
ing the hand positioned on the wheels.
Raise/lower the wheel.
Allow wheel to locate in desired position.
Make sure that all wheels are set to the same height.
Starting and Stopping
E
The blade continues to rotate for a few
seconds after the machine is switched off.
Allow the motor/blade to stop rotating be-
fore switching "on" again.
Do not rapidly switch off and on.
Starting:
Press and hold the safety button 2.
Squeeze the switch lever 1 towards the
0
handle.
2
Release the safety button 2.
1
I
Stopping:
Release the switch lever 1.
English - 3

Publicité

loading