Usb Messages; Resetting The Main Unit - Pioneer VSX-820-S Mode D'emploi

Additional information

USB messages

Symptom Cause
iPod/USB Error 1 There is a problem with the signal path
(I/U ERR1)
from the USB to the receiver.
iPod/USB Error 3
When there is no response from the USB. Switch off the receiver and reconnect
(I/U ERR3)
iPod/USB Error 4 The power requirements of the USB
(I/U ERR4)
device are too high for this receiver.

Resetting the main unit

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the BAND button,
press and hold the  STANDBY/ON button
for about two seconds.
3 When you see RESET? appear in the
display, press AUTO/DIRECT.
OK? shows in the display.
4 Press STEREO/ALC to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Action
Switch off the receiver and reconnect
the USB to the receiver.
the USB to the receiver.
Switch off the receiver and reconnect
the USB to the receiver.
11
79
En