KitchenAid KRFC704FBS Guide D'utilisation page 10

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Bottom Door Hinge
For your convenience, the refrigerator doors have bottom hinges
with door closers. These closers allow the doors to swing fully
closed with just a gentle push.
IMPORTANT: So that the closers feature will operate properly,
the doors must be removed only when open to a 90° angle to the
front of the cabinet. If one or both doors were not at a 90° angle
when removed, the bottom door hinge must be reset.
Reset the Door Hinge
1. Lift the door from the bottom hinge pin and place it on a flat
surface.
2. Using a TORX T25 screwdriver, remove the bottom hinge with
the bushing from the cabinet.
B
A. Bushing
B. Hinge base
10
3. Insert the bottom hinge and bushing into the corresponding
NOTE: Make sure that the base of the hinge is parallel to the
bottom of the door.
4. Turn the hinge until the hinge base is at a 90° angle to the
90°
5. Remove the hinge from the door. Using a driver with a
6. The hinge is now reset and prepared for the door to be
A
Remove Refrigerator Doors
Remove Right-Hand Door
1. Unplug refrigerator or disconnect power.
2. Keep the refrigerator doors closed until you are ready to lift
slot in the bottom of the door.
A. Hinge base parallel to the bottom edge of the door
bottom edge of the door.
A
90°
A. Hinge base turned to a 90° angle
with the bottom edge of the door
#2 square bit, reattach the bottom hinge to the refrigerator
cabinet.
replaced. See the "Replace Refrigerator Doors" section.
WARNING
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so can result in death or electrical shock.
them free from the cabinet.
NOTE: Provide additional support for the refrigerator door
while the hinges are being removed. Do not depend on the
door gasket magnets to hold the door in place while you are
working.
A