KitchenAid KRFC302EBS Guide De Démarrage Rapide

OPERATING INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS, located in your appliance's Owner's Manual, before operating this appliance.
IMPORTANT: Before operating this appliance, make sure it has been properly installed according to the
appliance's Owner's Manual.
The control center is located at the top front of the refrigerator compartment.
TEMPERATURE CONTROLS
For your convenience, your temperature controls are preset at the factory. When you first install your
refrigerator, make sure the controls are still set to the recommended set points as shown.
IMPORTANT:
■ The recommended settings should be correct for normal household refrigerator use. The controls are
set correctly when milk or juice is as cold as you like and when ice cream is firm.
IMPORTANT: When the power is on, the temperature display shows the set point temperature of the
compartment.
■ Wait 24 hours for your refrigerator to cool completely before adding food. If you add food before the
refrigerator has cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer controls to a colder than recommended setting will not
cool the compartments any faster.
■ If the temperature is too warm or too cold in the refrigerator or freezer, first check the air vents to be
sure they are not blocked before adjusting the controls.
Adjust Set Points
The first touch of the (+) or (-) touch pad displays the current temperature set point.
Press the (+) or (-) touch pads until the desired temperature set point is displayed.
NOTE: Except when first turning on the refrigerator, do not adjust either temperature control more than
one setting at a time. Wait 24 hours between adjustments for the temperature to stabilize.
Adjusting the Controls
The Refrigerator control adjusts the refrigerator compartment temperature. The Freezer control adjusts the
freezer compartment temperature.
If you need to adjust the temperature in either the refrigerator or freezer compartment, use the settings
listed in the chart below as a guide.
CONDITION:
Refrigerator too cold
Refrigerator too warm
Freezer too cold
Freezer too warm / too little ice
COOLING ON/OFF
Cooling On/Off turns off cooling for both compartments. It does not disconnect power to the
refrigerator.
■ Press and hold Cooling On/Off for 3 seconds. The LED will light up to indicate that
cooling is Off. Press the button again to turn on the cooling. The LED will turn off.
MAX COOL
The Max Cool feature assists with periods of high refrigerator use, full grocery loads, or
temporarily warm room temperatures.
■ Press Max Cool to set the freezer and refrigerator to the lowest temperature settings.
Press Max Cool again to return to the normal refrigerator set point.
NOTE: The Max Cool feature will shut off automatically in approximately 12 hours.
DOOR ALARM
The Door Alarm feature sounds a chime every few seconds when the refrigerator door has
been left open for 5 continuous minutes. The chime will sound until the door is closed or
Door Alarm is turned off.
■ Press the Door Alarm touch pad to turn this feature on or off. The indicator light will be lit
when the Door Alarm feature is on.
W11408553B
W11408560B-SP
French Door Bottom Mount Quick Start Guide
TEMPERATURE ADJUSTMENT:
Refrigerator setting 1° higher
Refrigerator setting 1° lower
Freezer setting 1° higher
Freezer setting 1° lower
WATER FILTER STATUS
The water filter status lights will help you know when to change the water filter. When the Order light is on,
it is almost time to change the water filter. When the Replace light is on, a new water filter should be
installed.
IMPORTANT: The disposable water filter should be replaced at least every 6 months. If the water flow to
the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water
filter more often.
FILTER RESET
The filter reset control allows you to restart the water filter status tracking feature each time
you replace the water filter. See "Water Filtration System" in the Owner's Manual.
■ After replacing the water filter, press and hold Filter Reset for 3 seconds, until the Order
or Replace light turns off.
HUMIDITY CONTROL
The Humidity Control feature turns on a heater to help reduce moisture on the door hinge seal.
Use in humid environments or when you notice moisture on the door hinge seal. The
refrigerator uses more energy when Humidity Control is on.
■ Press Humidity Control when the environment is warm and more humid, or if you notice
moisture on the door hinge seal. The indicator light will be lit when humidity control is on.
■ Press Humidity Control to off to save energy when the environment is less humid.
SABBATH MODE
The Sabbath Mode is designed for those whose religious observances require turning off the lights and
dispensers.
ON: All interior lights and alarm tones will be disabled.
OFF: All interior lights and alarm tones will be enabled.
■ Press and hold the Sabbath Mode touch pad for 3 seconds or until the indicator light is lit
to turn on this feature. Press and hold the Sabbath Mode touch pad again to turn off this
feature.
USER PREFERENCES
The control center allows you to set user preferences, if desired.
Temperature Display (F_C)
This preference allows you to change the
temperature display.
F - Temperature in degrees Fahrenheit
C - Temperature in degrees Celsius
To Access the User Preferences Menu:
1. Press and hold the Door Alarm touch pad for 3 seconds. The preference name will appear in the
freezer display and the preference status (F or C) or (On or Off) will appear in the refrigerator display.
2. Use the freezer (+) or (-) touch pads to scroll through the preference names. When the desired
preference name is displayed, press the refrigerator (+) or (-) touch pads to change the preference
status.
3. Set your preferences by pressing and holding the Door Alarm touch pad for 3 seconds, or by closing
the refrigerator compartment door.
Online Ordering Information
For detailed installation instruction and maintenance information, winter storage, and transportation tips,
please see the Owner's Manual included with your appliance.
For information on any of the following items, the full cycle guide, warranty, detailed product dimensions, or
for complete instructions for use and installation, please visit
https://www.kitchenaid.com/service-and-support, or in Canada
https://www.kitchenaid.ca/service-and-support. This may save you the cost of a service call. However,
if you need to contact us, use the information listed below for the appropriate region.
United States:
1–800–253–1301
KtichenAid Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022–2692
SAVE THESE INSTRUCTIONS
Alarm (AL)
This preference allows you to turn off the sound of
all alarms.
On – You will hear the alarm sound.
Off – You will not hear the alarm sound.
Canada:
1–800–807–6777
KitchenAid Brand Home Appliances
Customer eXperience Center
200–6750 Century Ave.
Mississauga, Ontario L5N 0B7