Publicité
Les langues disponibles
Les langues disponibles
> Before Start
> Part Names
Audio Adjust
∫ Dual Mono / Mono
Dual Mono
Set the audio channel or language to be output when playing
multiplex audio or multilingual TV broadcasts etc.
"Main (default value)": Main channel only
"Sub": Sub channel only
"Main / Sub": Main and sub channels will be output at the same
time.
0 If multiplex audio is being played, "1+1" will be displayed
when
Mono Input Channel
Set the input channel to use for playing any 2 channel digital
source such as Dolby Digital, or analog/PCM source in the Mono
listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right (default value)": Left and right channels
∫ Dolby
Loudness
When playing Dolby TrueHD, enable the dialog normalization
Management
function which keeps the volume of dialog at a certain level. Note
that when this setting is Off while playing Dolby Digital Plus/
Dolby TrueHD, the DRC function that allows you to enjoy
surround at low volumes is fixed to Off.
"On (default value)": When this function is to be used
"Off": When this function is not to be used
∫ Volume
Mute Level
Set the volume lowered from the listening volume when muting
is on. Select a value from "-¶dB (default value)", "-40dB", and "-
20dB".
Volume Limit
Set the maximum value to avoid too high volume. Select "Off
(default value)", "-32 dB" to "+17 dB".
> Install
on the remote controller is pressed.
> Initial Setup
> Playback
Power On Level
Headphone Level
Source
∫ Input Volume Absorber
Adjust the volume level difference between the devices connected to the unit. Select the
input selector to configure.
Input Volume Absorber Select from "-12.0 dB" to "+12.0 dB". Set a negative (j) value if
∫ Name Edit
Set an easy name to each input. The set name will be shown on the main unit display. Select
the input selector to configure.
Name Edit
Advanced Setup
| Supplementary Information | Others
Set the volume level of when the power is turned on. Select
"Last (default value)" (volume level before entering standby
mode), "-¶dB", "-81.5 dB" to "+18.0 dB".
0 You cannot set a higher value than that of "Volume Limit".
Adjust the output level of the headphones. Select from "-
12.0 dB" to "+12.0 dB". (Default Value is "0.0 dB")
the volume of the target device is larger than the others and a
positive (i) value if smaller. To check the audio, start playback of
the connected device. (Default Value is "0.0 dB")
1. Select a character or symbol with the cursors and press
ENTER.
Repeat it to input 10 or less characters.
"A/a": Switches between upper and lower cases. (Pressing
MODE on the remote controller also toggles between upper
and lower cases.)
" " " ": Moves the cursor to the arrow direction.
"
": Removes a character on the left of the cursor.
" ": Enters a space.
0 Pressing CLEAR on the remote controller will remove all
the input characters.
2. After inputting, select "OK" with the cursors and press
ENTER.
The input name will be saved.
49
En
Publicité
Chapitres
Dépannage
