Pioneer VSX-832 Mode D'emploi page 62

> Before Start > Part Names
MCACC" - "EQ Adjust" (P55) in the Home screen. The same sound field setting is applied all
ranges when set to "Off".
0 It cannot be set if the listening mode is Pure Direct.
Phase Control: Correct phase disturbance in the low range to enhance the bass. This
enables you to achieve powerful bass reproduction that is faithful to the original sound.
0 It cannot be set if the listening mode is Pure Direct.
Theater Filter: Adjust the soundtrack that was processed to enhance its high pitch range, in
order to make it suitable for home theater.
0 It cannot be set if the listening mode is Direct or Pure Direct.
∫ Other
Sound Delay: If the video is behind the audio, you can delay the audio to offset the gap.
Different settings can be set for each input selector.
0 This cannot be set if the listening mode is Pure Direct and the input signal is either
analog.
Sound Retriever: Improve the quality of the compressed audio. Playback sound of lossy
compressed files such as MP3 will be improved. The setting can be separately set to each
input selector. The setting is effective in the signals of 48 kHz or less. The setting is not
effective in the bitstream signals.
0 It cannot be set if the listening mode is Direct or Pure Direct.
DRC: Makes it easier to hear details even when the volume is low. It is useful when you
need to reduce the volume while watching a movie late night. Dolby You can enjoy the
effect only when playing Dolby series and DTS series input signals.
0 It cannot be set if the listening mode is Direct or Pure Direct.
0 The setting cannot be used in the following cases.
– When "System Setup" - "Audio Adjust" - "Dolby" - "Loudness Management" (P49) in
the Home screen is set to "Off" and Dolby Digital Plus or Dolby TrueHD is being played
– When the input signal is DTS:X and "Dialog Control" is other than 0 dB
Panorama: Broaden the sound field laterally when playing in the Dolby Pro Logic II Music
listening mode.
Dimension: Adjust the depth of the sound field in the front to back direction when playing in
the Dolby Pro Logic II Music listening mode. Set a small number to move the sound towards
the front. Set a large number to move the sound back.
Center Width: Adjust the width of the sound field of the front channel when playing in the
62
> Install > Initial Setup > Playback
Advanced Setup
Dolby Pro Logic II Music listening mode. Set a small number to concentrate sound in the
middle. Set a large number to distribute the central sound out to the left and right.
Dialog Control: You can increase volume of the dialog portion of the audio in 1 dB steps up
to 6 dB so that you can make dialog easier to hear over background noise.
0 This cannot be set for content other than DTS:X.
0 The effect may not be selectable with some content.
We plan to provide support for the Dolby Atmos audio format through firmware updates for
this unit. This means that the settings available depend on the version of firmware.
On firmware version before Dolby Atmos support
0 Panorama, Dimension, and Center Width can be set.
On firmware versions supporting Dolby Atmos
0 Panorama, Dimension, and Center Width cannot be set after updating.
| Supplementary Information | Others