Maintenance Instructions - CTEK MUS 4.3 TEST&CHARGE Manuel

STEP 1 DESULPHATION
Detects sulphated batteries. Pulsing current and voltage,
removes sulphate from the lead plates of the battery restor-
ing the battery capacity.
STEP 2 SOFT START
Tests if the battery can accept charge. This step prevents
charging of a defective battery.
STEP 3 BULK
Charging with maximum current until approximately 80%
battery capacity is reached.
STEP 4 ABSORPTION
Charging with declining current to maximize up to 100%
battery capacity.
STEP 5 ANALYSE
Tests if the battery can hold charge. Batteries that cannot
hold charge may need to be replaced.
STEP 6 RECOND
Choose the Recond program to add the Recond step to the
charging process. During the Recond step voltage increases
to create controlled gassing in the battery. Gassing mixes
the battery acid and returns energy to the battery.
STEP 7 FLOAT
Maintaining the battery voltage at maximum level by pro-
viding a constant voltage charge.
20018888_C.indd 13
STEP 8 PULSE
Maintaining the battery at 95–100% capacity. The charger
monitors the battery voltage and gives a pulse when neces-
sary to keep the battery fully charged.
MAINTENANCE
INSTRUCTIONS
The MUS 4.3 TEST&CHARGE (1077) is maintenance-free.
The charger must not be opened; doing so will invalidate the
warranty. If the power cable is damaged the charger must be
returned to the retailer. The charger casing can be cleaned
using a damp cloth and mild cleaning agent. Remove the plug
from the power socket before cleaning.
EN • 15
2017-05-24 13:20:45