Performing A Test - Fora 6 Plus Manuel De L'utilisateur

Do NOT rely on test results at an alternative sampling site,
but use samples taken from the fingertip, if any of the
following applies:
• You think your blood sugar is low.
• You are not aware of symptoms when you become
hypoglycemic.
• The results do not agree with the way you feel.
• After a meal.
• After exercise.
• During illness.
• During times of stress.
To obtain a blood sample from the alternative sites, please
rub the puncture site for approximately 20 seconds.
1. Replace the lancing device cap with the clear cap.
2. Pull the cocking control out until the orange bar appears
on the release button window.
Important!
• Do not use results from alternative site samples to calibrate
continuous glucose monitoring systems (CGMS), or for
insulin dose calculations.
• Choose a different spot each time you test. Repeated
1
2
punctures at the same spot may cause soreness and
calluses.
• Avoid lancing the areas with obvious veins to avoid
excessive bleeding.
• It is recommended to discard the first drop of blood as it
might contain tissue fluid, which may affect the test result.

Performing A Test

1. Insert the test strip into the test slot of the device. Wait for
the device to display the test strip "
".
2. Press to adjust the measuring mode, and press MAIN
button to confirm it.
• General Tests (
time since the last meal.
• AC ( ) - no food intake for at least 8 hours.
• PC ( ) - 2 hours after a meal.
• QC ( ) - testing with control solution.
3. Obtain a blood sample.
Use the pre-set lancing device to puncture the desired
site. Wipe off the first appeared drop of blood with a clean
cotton swab. Gently squeeze the punctured area to obtain
another drop of blood. Be careful NOT to smear the blood
sample.
EN-9
" and blood drop "
) - any time of day without regard to