Filling The Cartridge - Prebena KT-3500 Mode D'emploi Original

Servicing the Cartridge
In order to remove slight contamination on the hull, proceed as
follows:
 Wipe the cartridge with a cloth slightly moistened with mild soap
solution.
 Then wipe the cartridge with a cloth slightly moistened with tap
water.
 Then scrub it with a soft and dry cloth.
To clean the valve, proceed as follows:
 Blow out the inside of the valve.
 Wipe the outside of the valve with a cloth slightly moistened with
soap solution.
 Then wipe the outside of the valve with a cloth slightly moistened
with tap water.
 Then scrub it with a soft and dry cloth.
It is not permitted to clean the cartridge with means other than the
stated means.
 If you are unable to clean the cartridge as described, send it to
the manufacturer.

Filling the cartridge

You can fill the cartridge with the compressor of the PKT
FILLMASTER series available as accessory.
 Observe the compressor operating manual here.
You can also buy a full cartridge at a specialist shop in exchange for
an empty cartridge.
12
WARNING
Risk of explosion if the valve is damaged.
 Do not clean the valve with hard or pointed
objects.