Maintenance - Marshalltown Bullet 213-SID Mode D'emploi

The blade can be sharpened to restore a one-sided, 21° – 22° knife edge. It is important to note that the blade
must be sharpened only on the beveled side, leaving the flat side flat. We recommend that power grinding only
be done professionally, as the blade must be fluid cooled during this process.
!
USE EXTREME CAUTION! Blade is very sharp.
1. TURN THE SHEAR UPSIDE DOWN
Tip: put the shear on the edge of a sturdy table.
2. LOOSEN THE BLADE
Using a Phillips screwdriver, remove the screws
3. REMOVE BLADE
Hold blade by each end and carefully lift out of pocket.
4. INSTALL BLADE
Hold blade by each end and carefully place into the
blade pocket in the head, with the flat side of the
blade facing the table. Be sure that it is firmly seated,
and the pocket is clear of debris.
5. TIGHTEN THE BLADE
Using a Phillips screwdriver, replace & tighten the
screws, starting with the center screw.
WS2500
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

MAINTENANCE

Sharpening the Blade
CHANGING THE BLADE
WARNING
!
NOTE: This image is for the SharpShooter 2.0.
Your shear may look slightly different.
7 of 36