Operation - Beurer HT 80 Mode D'emploi

Note
• Remove all packaging material before using the device.
• Only connect the device to a socket using the voltage specified on
the type plate.
• If you do not know the local mains voltage, request it from the rele-
vant organisation.
• Only pull the mains cable from the socket by the mains plug.
• Do not use any additional parts that are not recommended by the
manufacturer or offered as accessories.
• Under no circumstances should you open or repair the device your-
self, as faultless functionality can no longer be guaranteed thereafter.
Failure to comply will result in voiding of the warranty.
• In the event of a fault or damage, have the device repaired by a certi-
fied specialist workshop.
• Never leave the device unattended during use.
• Do not use the device outside.
• If you pass on the device to someone else, make sure to also pass
on these instructions for use.

6. Operation

Warning
• Position yourself on a dry, non-conductive surface. Risk of electric
shock!
• Make sure that your hands are dry! There is a risk of electric shock!
• The heated brush [2], the curling brush [3] and the device may be-
come very hot depending on the switch setting and period of use –
risk of burns and fire! Do not touch the heated brush [2] or the curling
brush [3].
• Place the device on fireproof surfaces only. Risk of fire!
• Ensure that no hair can be directly sucked into the device. Risk of
fire!
23