General Instructions For Use - Beurer HT 80 Mode D'emploi

Important
• Do not jam the mains cable [11] in drawers or doors, for example.
• Untangle the mains cable [11] if it is twisted.
• Do not pull, twist or bend the mains cable [11] and do not pull or
route it over/on sharp, pointed objects or hot surfaces.
Note
A slight odour initially develops after switching on the device for the
fi rst time. This is normal and not harmful to your health. Allow the de-
vice to run for three to fi ve minutes. After that you can use the device
as normal.
• For your safety, the device switches off automatically if it overheats.
• Pull the mains plug out of the socket and allow the device to cool
down.
• Before switching the device back on, check the air outlet [4] and the
air intake fi lter [8] for any blockages (e.g. sucked-in fl uff , dust or hair).

6.1 General instructions for use

Step 1: Attaching/removing the brush
attachment
To attach a brush attachment to the hot
>
air brush, place the required brush at-
tachment on the hot air brush and care-
fully turn it right and left until you see
and hear it click in place.
To remove a brush attachment from the
>
hot air brush, hold down the unlock but-
ton [1] on the brush attachment and pull
the attachment off the hot air brush.
> Allow the heated brush [2] and the cur-
ling brush [3] to cool before you remove them.
24