Cleaning - Beurer HT 80 Mode D'emploi

Hold this position for approximately 20 seconds.
>
After the 20 seconds, slide the sliding switch [6] to the
>
fi nish the section.
Use the rotation button to unwind the section completely in the op-
>
posite direction.
Repeat steps 1 to 6 to curl the rest of your hair.
>
Round brushing inwards:
Use the heated brush [2].
>
If you have fi ne hair, slide the sliding switch [6]
>
to position 1.
If you have thick hair, slide the sliding switch [6]
>
to position 2.
Place the heated brush [2] under a section of
>
hair at the tips.
Hold down the wind rotation button until the tips
>
curl in as required.
Hold this position for approximately 20 seconds.
>
After the 20 seconds, slide the sliding switch [6] to the
>
fi nish the section.
Use the rotation buttons to unwind the section completely in the op-
>
posite direction.
Repeat steps 1 to 6 to curl the rest of your hair.
>
Note
• If your hair becomes knotted while winding or unwinding, switch off the
device and carefully release the hair from the attachment.

7. Cleaning

Important
• Always pull the mains plug out of the socket before cleaning the device.
Risk of electric shock!
• Ensure that no water gets inside the device! Risk of electric shock!
27
position to
position to