Beurer IPL 7500 Mode D'emploi page 8

6 Socket for device plug
7 Mains adapter
8 Trigger button
ON/ OFF power/ energy selection button
• Press the ON/ OFF power/ energy selection button (after
the device is connected to the power supply) to activate
device at Level 1. Each press will increase the energy
level from 1 through 3.
• Press and hold the ON/ OFF power/ energy selection
button for three seconds to shut the device off. The de-
vice will also shut off by itself if not touched for 180
seconds.
The Trigger button (flash pulse activation) activates the flash
lamp as long as the treatment window is in full contact with
the skin and the skin tone is in the allowed range. Press the
trigger button once to emit a single pulse; press and hold
the trigger button for continuous pulses.
Indicator Mode
No light OFF
Blinking Standby
green light
Green Energy
energy level 1-3
level LEDs
(1 -3)
Steady ON
green light
Short Activation
orange (pulse)
light flash blocked
Short red Activation
light flash (pulse)
blocked
8
Description
Device not working (not
connected to the power
supply)
Device is in standby mode
(when first powering on
or when no buttons are
pressed for 3 minutes)
The three energy levels are
indicated by three green
LEDs.
Pulse is ready
The device does not deliver
a pulse due to the lack of
full skin contact.
The device does not deliver
a pulse due to non-allowed
skin tone.