Back Panel; Battery Operation; Charging The Battery - SOUNDMASTER Highline DAB100 Mode D'emploi

8. P1/P2/P3/P4/P5
- Press "P1"/"P2"/"P3"/"P4"/"P5" to recall the preset stations.
- Press and hold "P1"/"P2"/"P3"/"P4"/"P5" (DAB/FM) to save the current broadcasting
station into that preset key memory. It has 5 DAB and 5 FM preset memory
9. VOL-
- Press "VOL-" button to decrease the volume, Volume level from 0 to 20
10. VOL+
- Press "VOL+" button to increase the volume, Volume level from 0 to 20
11. SELECT
- Press "SELECT" button to select the highlighted menu item
12. Main Speaker
- 3" speaker drive is built-in

BACK PANEL

13. AUX IN Socket
- Connect a stereo or mono audio source to the AUX IN socket i.e. iPod, MP3 Player, CD
player... etc
14. PHONES Socket
- Connect a headphone to this 3.5mm headphone socket to listen the unit. Inserting plug
automatically mutes the internal loudspeaker.
15. DC Socket
- Connect the power adaptor's DC plug to the DC socket on the rear cabinet. Then connect
the power plug on the other end to an AC outlet.
16. Adjustable
- Adjust this adjustable antenna and position it for best DAB or FM reception.
Antenna
- Retract the antenna when using/connecting the AUX IN or not using the unit
17. DC On/Off
- Turn 'ON' the DC switch to connect the batteries power
- Turn 'OFF' the DC switch to cut off the batteries power when not using the unit.
18. Battery
- 1 pack AA size rechargeable batteries is installed into the battery compartment
Compartment

BATTERY OPERATION

- A complete charge should take up to Min. 5 hours with the unit switched to the 'Standby' mode, it provide for
approximately 5 hours for listening at normal volume. The letter 'B' will appear on the left of LCD display.
- When the battery is low, a symbol 'Empty Battery' flashing on the left of the LCD display. After few second, it
will return to standby mode.
- When charging the battery, the display will light on and has a letter 'B' flashing on the left of LCD display. After
60 sec, the light will turn off and the time and date will display on the LCD display.
- When the battery is fully charged during the AC power cable is connected, the letter 'B' will disappear.
- Reduced power, distortion and a "stuttering" sound are all signs that the battery may need recharging.
- If the radio is not to be used for any extended period of time, it is recommended to long press the 'STANDBY'
key to disconnect the unit.

CHARGING THE BATTERY

To charging the battery, turn 'ON' the "DC" switch. Connect the AC power cable into the AC Input socket at the
back of the unit and connecting to AC230V~50Hz house.
NOTE: CAN ONLY BE CHARGED IN "STANDBY" MODE WITH THE SWITCH IN DC POWER.
(DAB) Cycle through the available station, push "SELECT" button to confirm selection
and start the DAB broadcast.
(FM) Manual tune FM frequency, push "UP"/"DOWN" button step by step to select
the active frequency range.
(All setting modes) Press and hold "UP"/"DOWN" button to the next available
station.
- In Strong FM signal location(s), reduce the length of antenna until better reception.
- If FM reception is unsatisfactory, turn the unit slightly until reaching the best reception.
ENG 2
DAB100 / English Manual