Md Playing; Basic Operations - Aiwa CSD-MD5 Mode D'emploi

MD PLAYING

BASIC OPERATIONS

2
sSTOP
zMD
EJECT
DISP
1
Insert a disc into the disc drive with the label
side up and in the direction of the arrow.
Arrow
2
Press MD e to start play.
Track number or track title*
Track number
* applicable when the track title is registered.
To stop play, press s STOP. MD s on the remote control
is also available.
To pause play, press MD e. To resume play, press
again.
To search for a particular point during play, keep r or
t pressed and release it at the desired point.
To skip to the beginning of a track, press r or t
repeatedly or turn JOG DIAL until the desired track is
displayed.
To remove the disc, press z MD EJECT.
To start play when the power is off
Press MD e. The power is turned on and play of the
loaded disc begins.
8
ENGLISH
r, t
RANDOM
REPEAT
1
JOG DIAL
MDs
r, t
Elapsed playing time
To check the remaining time
During play, press DISP repeatedly.
Each time it is pressed, the display changes cyclically.
1 Elapsed playing time of the track
2 Remaining time of the track
3 Remaining time of the disc
1 TRACK is lit up on the display.
2 TRACK and REMAIN are lit up on the display.
0-15, +10
3 TOTAL and REMAIN are lit up on the display.
2
You cannot check the remaining time of the disc when
RANDOM or " 1 is lit up.
To select a track with the remote control
Press the numbered buttons 0-15 and +10.
Example:
To select the 25th track, press +10 twice and 5.
To select the 20th track, press +10 twice and 0.
MD play starts from the selected track and continues to the
last track.
To play a disc at double speed
Press × 2 on the remote control during play.
To resume normal play, press again.
When using the main unit, keep MD e pressed during
regular play until disc plays at double speed.
To resume, repeat the above.
Display information in stop mode
Total number of tracks or disc title*
Total number of tracks
* applicable when the disc title is registered
TOC READING is displayed while:
The unit reads the data on the inserted disc. After
completion, the information contained in the disc is
displayed.
NOTE
• Do not open or close the operating panel while ejecting the
disc, otherwise a disc may be scratched.
• Do not hold the disc while ejecting it, otherwise a disc
cannot be inserted the next time.
If this happens, turn off the power and disconnect the AC
cord. Then connect it again.
• Nothing other than an MD should be inserted into the disc
drive. Otherwise the disc may become scratched, causing
a malfunction or safety hazard such as an electric shock.
• Do not attempt to insert another MD while a disc is already
inside the drive.
• Do not tilt the unit with disc loaded. Doing so may cause
malfunction.
↓
↓
↓
Total playing time