Md Recording; Recording A Whole Cd - Aiwa CSD-MD5 Mode D'emploi

MD RECORDING

RECORDING A WHOLE CD

sSTOP
2
2
1
Insert a recordable MD into the disc drive with
the label side up and in the direction of the
arrow.
Arrow
2
Load a CD and press CD c MD in stop mode.
CD c MD DIRECT is displayed and the recording
begins.
Remaining recordable time of the MD
Elapsed playing time of the CD
When the last track of the CD finishes playing, the recording
stops automatically.
When the recording finishes, TOC-EDIT flashes while the
data concerning the contents of the recording are registered.
• The track order information in the original CD will be
copied as the index marks.
14
ENGLISH
To stop recording
Press s STOP. Recording stops and TOC data is
registered.
To stop playing the CD, press s STOP again.
When pressing CD s on the remote control, recording and
CD play stop simultaneously.
• When pressing DISP in stop mode, the remaining
1
recordable time is displayed for 4 seconds.
To record on a previously recorded MD
DISP
If there is an unrecorded section left on the MD, the new
recording automatically starts from where the previous
recording finished.
If you want to start recording from the beginning of a
previous recorded MD, erase the previous recording
completely. (See page 21.)
CDs
T. OVER is displayed when:
The remaining recordable time of the MD is not enough to
record a whole CD.
Press s STOP and replace the MD with another one.
If it does not matter whether recording is cut short or not,
press CD c MD again to start recording.
Registering the index mark automatically
- When recording from a CD, the index mark information
recorded on the CD is copied as it is.
Recording (MD)
- When recording from the radio, the index mark information
is registered every 5 minutes.
NOTE
There may be a case where index marks are not registered
accurately.
2nd 3rd
CD
track track
2nd 3rd
track track
: Index mark
4th
track
4th
track