Guided Tour - Crnd Receiver - Samson CONCERT IV Manuel Du Propriétaire

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

1: Antenna mounting - Connect the

supplied antenna to this mounting.

Third-party receiver antennas should not

be substituted—use only the antenna

provided with the CRND. See the

"Setting Up and Using the Concert IV

System" section on page 6 for more about

antenna installation and positioning.

2: "TX ON" LED - Lights when carrier

signal of sufficient strength is being

received by the CRND.

3: Squelch control - This control determines the maximum range of the CRND before audio signal

dropout. It should normally be left at its factory setting. For more information, see the "Setting Up and

Using the Concert IV System" section on page 6 in this manual.

4: Peak LED - This LED lights when output signal from the CRND is at the onset of clipping (that is,

when it is on the verge of being distorted). If you see this light during operation, move the microphone

further away or lower the output level of your instrument or transmitter. For more information, see the

"Setting Up and Using the Concert IV System" section on page 6 in this manual.

5: Volume - This knob determines the level of the audio signal sent from the unbalanced output jack on

the rear panel.

6: Power LED - Lights whenever the CRND is powered on.

7: DC input - Connect the supplied AC

adapter here. WARNING: Do not substitute

any other kind of power adapter; doing so

can cause severe damage to the unit and

will void your warranty.

8: Unbalanced output - Use this

unbalanced high impedance (5K Ohm)

1/4" jack to connect the CRND to the

microphone input of your mixer. The jack is

wired as follows: tip hot, sleeve ground.

9: Rear-mount antenna knockout - The CRND antenna (normally mounted on the front panel) can

optionally be mounted on this area of the rear panel. Contact Samson or your local distributor for further

information.

Rack-mounting the CRND

As shown in the illustration below, one or two CRND receivers can be mounted in a single 19" rack space

with the use of an optional adapter available from Samson or your local distributor.