Bosch GKF12V-25 Consignes De Fonctionnement/Sécurité page 10

160992A400_GKF12V-25 10/9/17 2:58 PM Page 10
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
TURNING TOOL ON AND OFF
Make sure that the spindle locking bar 7 is
pressed into disengaged position.
To switch the power tool ON, slide the
On/Off switch 5 down so that "I" appears on
the switch.
To switch the power tool OFF, slide the
On/Off switch 5 up so that "O" appears on the
switch (Fig. 1).
SETTING THE DEPTH OF CUT
Adjust the depth-of-cut only when the motor is
switched off.
Remove the battery pack and make
sure the switch 5 is in the "O" (off)
position.
1. Install desired router bit according to the
instructions on page 8.
2. Place the router on the workpiece.
3. Turn the depth-of-cut locking wheel 14
counterclockwise
approximately half a revolution to unlock
depth-of-cut adjustment (Fig. 6).
4. Press depth-of-cut adjustment button 8 and
slowly lower the router to approximately
desired depth of cut. Release the button 8
(Fig. 6).
5. Use the thumbwheel 10 to set the exact
cutting depth required. Each revolution of
the thumbwheel changes the cutting depth
by 0.04 in (1 mm).
6. Turn the locking wheel 14 clockwise
(towards ) to securely lock the depth-of-
cut adjustment.
7. Insert the battery pack. Check the adjusted
depth with a trial cut. If necessary, remove
the battery pack and re-adjust the depth of
cut.
8. If you want to keep the tool fixed at the
cutting depth you have set, you can screw
the fixing screw 11 into the depth-of-cut
adjustment thumbwheel 10. You will need
a flat head screwdriver (not included) with
5/32" (4mm) maximum width (Fig. 7).
Operating Instructions
Disconnect battery pack
from tool before making
(towards
FIG. 6
FIG. 7
)
BATTERY CHARGE CONDITION
INDICATOR
Your tool is equipped with charge condition
indicator lights 4 (Fig. 1). The indicator lights
show the charge condition of the battery for a
few seconds the tool activation.
LED
3 continuous green lights
2 continuous green lights
1 continuous green light
1 flashing green light
-10-
14
8
10
11
10
11
Capacity
> 2/3
> 1/3
< 1/3
reserve