Briteq LDP-COBWASH 60TC Mode D'emploi page 9

ENGLISH
DMX ADDR
Used to set the desired DMX-address.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired DMX512 address. The last occupied DMX-address is
also shown: makes it easier to set the address of the next unit in the chain.
 Once the correct address shows on the display, press the ENTER button to save it.
Note: on RDM-compatible controllers this option can also be remotely set.
CH. MODE
Used to set the desired channel mode.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 CH:03
R, G & B can be set separately, no master dimmer.
 CH:04
R, G & B can be set separately, with combined strobe + master dimmer on CH4.
 CH:04+ R, G & B can be set separately, with master dimmer on CH4. (no strobe)
 CH:06
R, G & B can be set separately, with separate master dim, strobe and color fade channels.
 Once the correct option shows on the display, press the ENTER button to save it.
Remark: on RDM-compatible controllers this option can also be remotely set.
SLAVE MODE
Used to set the projector as slave in a master/slave setup.
 Press the MODE button until SLAVE MODE is showing on the display.
IR-REMOTE
Used to set the wireless remote function on/off.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to select the desired mode:
 OFF
The unit does not accept commands from the supplied remote controller.
 ON
The unit can be controlled by the supplied remote controller.
 Once the correct option shows on the display, press the ENTER button to save it.
EFFECT MODE
Used to set the desired effect mode while used as master.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to selected the desired mode:
 COL.CH7
 COL.CH3
 COL.FADE
 Once the correct option shows on the display, press the ENTER button to save it.
 Use DOWN and UP buttons to select the desired playback speed from 01 (very slow) to 99 (fast).
 Once the correct value shows on the display, press the ENTER button to save it.
 Use DOWN and UP buttons to select the desired strobe speed from 00 (NO strobe) to 99 (fast).
 Once the correct value shows on the display, press the ENTER button to save it.
STATIC COLOR MODE
Used to set the desired fixed color while used as master: 9 preset colors + 1 custom color.
 Press the MODE button until the desired function is showing on the display.
 Press the ENTER button: the values can be changed
 Use DOWN and UP buttons to selected the desired color:
 COLOR WW
 COLOR CW
 RED
 ORANGE
 YELLOW
BRITEQ
®
(COLOR CHANGE 7) 7 colors change automatically without fading.
(COLOR CHANGE 3) red, green and blue change automatically without fading.
(COLOR FADE) colors change with a nice fading effect.
warm white 3200K
warm white 5600K
7/64 LDP-COBWASH 60TC + 150TC
OPERATION MANUAL