Briteq LDP-COBWASH 60TC Mode D'emploi page 13

ENGLISH
4 channel DMX-Mode: RGB + MASTER DIM / STROBE
Note: This mode can be used with LEDCON-02 Mk2
Channel: Value:
1 000-255
2
000-255
3 000-255
000-200
4 201-247
248-255
4+ channel DMX-Mode: RGB + MASTER DIM (NO STROBE)
Channel: Value:
1 000-255
2
000-255
3 000-255
4 000-255
6 channel DMX-Mode: all pixels working together in RGB + MASTER DIM + STROBE
Channel: Value:
1 000-255
000-007
2
008-255
000-007
3
008-255
4 000-255
5 000-255
6
000-255
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified technician!
BRITEQ
®
Function:
Red (0-100%)
Green (0-100%)
Blue (0-100%)
Master dimmer
Strobe
Master dimmer @ 100%
Function:
Red (0-100%)
Green (0-100%)
Blue (0-100%)
Master dimmer
Function:
Master dimmer (0-100%)
No strobe (open)
Strobe
No function
Color fade effect
Red (0-100%)
Green (0-100%)
Blue (0-100%)
11/64
OPERATION MANUAL
Remarks
000=0% ~ 200=100% (full open)
Increasing speed: 201=slow ~ 247=fast
Master dimmer is full open
Remarks
000=0% ~ 255=100% (full open)
Remarks
Increasing speed: 008=slow ~ 255=fast
Channels 4+5+6 are active
Increasing speed: 008= very slow ~ 255=fast
Not used while CH3 = 008 ~ 255
Not used while CH3 = 008 ~ 255
Not used while CH3 = 008 ~ 255
LDP-COBWASH 60TC + 150TC