Important Safety Instructions - Haussmann HMS115 Manuel De L'utilisateur

TABLE OF CONTENTS
Parts list and schematic drawing ................................................................... p.9

Important safety instructions ......................................................................... p.10

Stand-specific safety instructions .................................................................. p.10

Stand features ............................................................................................... p.11

Package contents .......................................................................................... p.11

Assembly instructions .................................................................................... p.12

Mounting non-standard mitre saws ............................................................... p.13

Set-up / knock-down procedures ................................................................... p.14

Warranty ........................................................................................................ p.15


IMPORTANT SAFETY INSTRUCTIONS

ALL
READ INSTRUCTIONS BEFORE USING THIS PRODUCT
We strongly recommend that this tool not be modified and/or used for any
application other than that for which it was designed. If you have any questions
relative to its application, do not use the equipment until you have consulted us
and we have advised you.
1. KEEP WORK AREA CLEAN. Cluttered areas invite injuries.
2. CONSIDER WORK AREA ENVIRONMENT. Do not use power tools in damp,
wet, or poorly lit locations. Do not expose your tool to rain. Keep the work area
well lit. Do not use tools in the presence of flammable gases or liquids.
3. KEEP CHILDREN AND BYSTANDERS AWAY. All children should be kept
away from the work area. Don't let them handle machines, tools or extension
cords. Visitors can be a distraction and are difficult to protect from injury.
4. WEAR EYE PROTECTION. If your operation generates dust or wood chips or
other debris, wear a full facial mask. Protection glasses are adapted for other
operations. Wear a dust mask if the operation generates dust.
5. STORE IDLE EQUIPMENT. Store equipment in a dry area to inhibit rust.
Equipment also should be in a high location or locked up to keep out of reach
of children.
6. STAY ALERT. Watch what you are doing & use common sense. Don't operate
any tool when you are tired, or under the influence of alcohol, drugs or
medication.
7. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
reach over or across running tools.
STAND-SPECIFIC SAFETY INSTRUCTIONS
1. To obtain maximum stability, use the mitre saw stand on a flat surface ONLY.
2. Be careful while raising and lowering the stand to prevent pinching your fingers
or hands.
3. Be sure the snap buttons on each leg are in the locked position before
beginning work to ensure the stand remains rigid during cutting.
4. Do NOT step or climb on the stand at any time. Doing so can cause damage to
the stand and/or personal injury.
5. Before operation, ensure that the mitre saw is fastened securely to the stand to
prevent unwanted movement of the saw.
6. Before operation, make sure that the material supports are locked in place.
7. The main frame can support up to 500 lbs (225 kg) total weight (saw +
material). It is critical that you do not exceed this weight for reasons of personal
safety and to prevent damage to the stand.
WARNING: The warnings, cautions, and instructions detailed in this manual
cannot cover all possible conditions and situations that occur. It must be
understood by the operator that COMMON SENSE AND CAUTION ARE
FACTORS that cannot be built into this product, but MUST BE SUPPLIED BY
THE OPERATOR.
10
!
!