EuroLite Pro-Controller Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DESCRIPTION
Frontpanel:
1
+
1
POWER
o
+
GN-2110
14
1. ON/OFF-switch with LED-display
2. Zone button with LED-display
3. Synchronisiation button for synchronising all selected zones
4. Automode. Chased all selected zones
3&4. Synch + Auto. Runs as chaser through the zones and flashes synchronously.
5. Speed control for adjusting the flash speed
6. Control for adjusting the flash rate
7. Trigger-button for manual triggering of a flash. Therefore, the master button has to be pressed.
8. Audio-button for activating the sound-control
9. Manual-button for trigger operation
10. Flash-button for flashing all tubes at once
11. Auto reverse. The flash runs forward and then backward
12. Crossover. Flash starts at both ends of the tube(s) and run into centre
13. Backward-button: flash runs backwards from one end of the tube(s)
14. Forward-button: flash runs forward
Rearpanel:
+
+
15. IEC output-sockets for zone output
16. Circuit breaker
17. Power connection
CAUTION: Only use the original cable in order to connect the flashtubes. Please note that for maximum
operation (4x10 tubes) 15 Amps are required.
2
ZONE CONTROL
2
3
MODE SELECT
13
12
15
+
+
3
4
+
Auto
4
Sync
Manual
+
Flash
10
9
11
+
+
9
5
6
PULSE CONTROL
Speed
Rate
Audio
Trigger
8
7
16
17
+
+
+
+

Publicité

Table des Matières
loading

Table des Matières