emerio FH-117208 Mode D'emploi page 7

3. Timer / Temperature button
Timer: Press the button
timer value with a symbol "h" will be shown on the digital display. The set timer will be activated in 5 seconds
without any other operation and then the digital display will show back the set temperature.
Temperature: Press the button
temperature value with a symbol "
activated in 5 seconds without any other operation.
Note:
1) After timer and temperature are set, the digital display will show the set time and temperature alternatively.
If you do not set the timer and only set the temperature, the digital display will show the set temperature
only.
2) Once the timer is counting down to 0 (not shown on digital display), the appliance will stop working
automatically and enter into standby mode.
3) Once the set temperature is reached, the appliance will stop working, as well as the swing function if you
have set before. Once the room temperature is lower than the set temperature by 2℃, the appliance will
resume working automatically, as well as the swing function if you have set before. If you have set the timer,
please note the time for standby mode will not be counted as the set time.
4) This appliance begins to sense the room temperature in 10 seconds after the appliance is turned on, so even
your set temperature is already above the current room temperature, the appliance will still work for 10
seconds and then turn off automatically.
4. Power setting button
Under working condition, you can press button "
and high heating power. This button is inactive when the appliance stops working.
- Low heating power: Icon "
- High heating power: Icon "
5. ECO button
Under working condition, you can press button "
will illuminate on the digital display. When the ECO function is operating, the button "
adjustment are not active. You can press button "
When appliance is in ECO mode, the temperature will be set at 22℃ by default. Under this condition, when the
room temperature is lower than 18℃, the high heating power works automatically; when the room temperature
is higher than 18 ℃ but lower than 22 ℃ , the low heating power works automatically. When the room
temperature reaches 22℃, the appliance stops working automatically.
6. Fireplace illumination button
Press the button "
to set the timer from 0 – 24hours (0 = no timer). The corresponding
or
or
℃" will be shown on the digital display. The set temperature will be
SET
" will be shown on the digital display.
" will be shown on the digital display.
" to turn on or turn off the fireplace illumination.
to set the temperature from 15 – 35℃. The corresponding
" to switch the power setting between low heating power
" to switch the appliance into ECO mode. The icon "
" again to exit form ECO mode.
- 6 -
"
" and temperature