emerio FH-117208 Mode D'emploi page 6

FH-117208 EN
PARTS DESCRIPTION
1. Control panel
2. Digital display
3. Remote control
4. Air outlet
5. Base
6. Fireplace illumination
7. Remote control storage
8. Air inlet
9. Power switch
Control panel
a. ON/OFF button
b. Power setting button
c. ECO button
d. Oscillation button
e. Fireplace illumination button
f. Timer button
g. Temperature button
ASSEMBLY
Remove the appliance from the packaging. Upside the appliance body. Attach the base onto the bottom of the
body and fix with the four tabs buckled firmly.
OPERATION
Plug the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the power switch.
Beep sound will be heard. The appliance is standby with the icon " " illuminate on the digital display. Press
the on/off button on the control panel to start setting your heater.
1. On/off button
Press the button " " to run your heater under low heating power with icon " " illuminating on digital
display. The digital display shows the set temperature 25℃ by default. Once the set temperature is reached, the
appliance will stop working. Press the button " " again, the digital display will count down from 10 to 0 to
shut down the appliance.
2. Oscillation button
Under working condition, you can press button " " to activate or deactivate the swing function. The digital
display will show icon " " lighted on when swing function is activated. When temperature is reached and
appliance stops working, the oscillation will also stop and only restart when the appliance starts working again.
You cannot activate the oscillation when the appliance is not working.
- 5 -