Selecting And Starting The Program; End Of Program; Interrupting A Program; Changing The Current Program - Fagor LFA086XL Manuel D'utilisation

EN
3.2.2

Selecting and starting the program

• Press the
the indicator light corresponding to the required program turns on (ref. 2 fi g.
3-02);
• if required, press the relative buttons to select any complementary functions
(e.g.: "half-load", "program delay"; see para 3.2.7 "options");
• close the door; the program will start after about
indicator light will fl ash throughout the cycle (program running signal).
SUPPLEMENTARY PROGRAMS
The supplementary program button (ref. 6 fi g. 3-02) adds fi ve extra programs
to the ones that can be directly selected with the program selection button.
Press the supplementary program button (the indicator light turns on) after
selecting the "main" program (see 1, 2, 3, 4, 5 in table. 3-02a).
As the function is memorized, press the button again (the indicator light turns
off) if you wish to run one of the 5 main programs for the next cycle.
3.2.3

End of program

The end of the program is signaled by a short beep. Additionally the indicator
light of the standard and supplementary programs (marked "end") fl ash.
3.2.4
To interrupt the current program simply open the door of the dishwasher; to
restart the program, simply close the door again. The program restarts from
where it was interrupted.
3.2.5

Changing the current program

To change the current program, simply open the door of the dishwasher and
select the new program. Close the door to run the new program automatical-
ly.
16
program selection button (ref. 3 fi g. 3-02) several times until
If the door of the dishwasher has not been closed or has been incor-
rectly closed, the washing cycle will not begin.

Interrupting a program

USER INSTRUCTIONS
2 seconds and the relative
Rev 0.0