Peg-Perego BACKHOE LOADER Utilisation Et Entretien page 11

the vehicle on one side, holding the left wheel
with the implement on the lower side. Be
careful that the implement does not move out
of place.
15 • Insert the other conical implement provided
into the right wheel, as shown in the figure, and
hammer into place.
16 • Place a washer on the fore carriage pin as
shown in the figure.
17 • Fit one of the two small wheels. Make sure the
tread is facing the right way.
18 • Insert a self-locking washer into the implement
provided (see figure). WARNING: the tabs of the
self-locking washer must be facing the inside of
the implement (refer to detail A).
19 • Attach the wheel in place, as in the figure,
pushing the self-locking washer as far as
possible. Carry out the operations shown in the
figures to fit the remaining front wheel (figures
16-17-18-19).
20 • Clip the 4 hub covers onto the wheels of the
vehicle.
21 • Unscrew the cover situated on the back of the
electronic unit. Insert two 1.5 V batteries (not
supplied) into the battery unit, making sure you
put them in the right way round. Close and
screw down the cover.
22 • Attach the electronic unit, inserting both tabs
into the slots in the bodywork, as shown in the
figure, and fasten down with the screw.
23 • Join together the two parts of the steering
wheel.
24 • Position the steering wheel in place. Secure the
steering wheel with the washer and screw
provided.
25 • Clip the steering wheel cover cap in place, as
shown in the figure.
26 • Place the handle on the arms of the shovel unit,
tilting it downwards slightly in order to position
the two clips on the handle correctly (refer to
the detail in the following figure).
27 • The two clips on the handle must be left on the
outside of the hooks that stick out from the
arms of the shovel unit. The figure shows one of
the two clips in an incorrect position (NO) and a
correct position (OK).
28 • Insert the tabs on the front of the handle into
the openings in the arms of the shovel unit.
29 • Fix the handle using the screws and the nuts.
Insert the nuts in the hexagonal housing on the
inside of the arms of the shovel unit and the
screws through the circular holes, from the
outside (the figure shows the lower part of the
arms of the shovel unit).
30 • Finally, to complete the fitting of the handle, fix
the nuts in position and tighten the screws.
31 • Insert the shaft of the control lever for the
bucket in the hole in the bucket.
32 • Place a large stud in the special implement (see
detail A).
33 • Fix the shaft by completely inserting the stud (if
necessary use a hammer).
34 • Mount the 2 head lights, pushing them in
correctly as shown in the detail above.
35 • Push on the two support sleeves of the bucket
on the sides of the grille, as shown in the figure.
Please note, the pieces are shaped to follow the
line of the grille. Insert piece L on the left and
piece R on the right.
36 • Fold down the front shovel unit and insert the
grille from above (make sure the grille is facing
the right way).
37 • With the grille in place, insert the screws
provided with the respective washers and nuts.
(See detail A).
38 • Tighten the screws with a screwdriver, using a
pair of pliers to keep the bolt still on the inside.
39 • Take the assembled front shovel unit and insert
the upper fasteners of the already-mounted
grille into the appropriate holes in the front
part of the chassis.
40 • Turn and lower the front grille to clip on the
two lower teeth in the respective slots in the
chassis.
41 • Connect the battery plug to the system plug.
42 • Insert the hood, making sure that the fasteners
are inserted correctly in the respective housing
on the chassis and the false motors. See details
A and B.
43 • Screw down the hood.
44 • Lower the front shovel unit until it locks with
the two external fasteners located near the
steering wheel.
45 • Insert the filler in the end of the arm (see
operation A). Using the 2 black plastic plugs,
attach the smaller rear bucket to the arm (see
operation B). Then, using a screw and a
screwdriver, attach the black plastic handle to
the bucket (see operation C).
46 • Snap in the two plugs on the joint of the rear
arm (see operation 1). Next, insert the arm into
the hole on the rear end of the vehicle (see
operation 2).
VEHICLE CHARACTERISTICS AND USE
47 • ELECTRONIC UNIT:
Left button: Flashing lights
Right button: Roaring engine
You are advised to turn the key anti-clockwise after
use in order to avoid flattening the battery.
48• ELECTRIC ACCELERATOR/BRAKE PEDAL: the
brake will automatically be applied when the
foot is raised.
49 • To empty the front bucket, lower the lever.
50 • To lower the entire front shovel unit, push the
handle forward.
51 • REAR BUCKET: to operate the rear bucket, use
the black handle.
REPLACING THE BATTERY
52 • Lower the front shovel unit by pushing the
handle forward and unscrew the hood.
53 • Pull the hood towards you, raising it with
circular movements, and take it off.
54 • Remove the 2 screws on the battery holder.
55 • Disconnect the 2 plugs and remove the battery
provided.
56 • Insert the replacement 6V-8 Amp battery,
connecting the 2 plugs.
57 • Screw down the battery holder, turning it over
as shown in the figure. Close the hood as
previously described (fig. 42) and attach it in
place with the screws.
CHARGING THE BATTERY
WARNING: BATTERY CHARGING AND ANY WORK ON
THE ELECTRIC WIRING UNIT MUST BE CARRIED OUT
BY ADULTS.
THE BATTERY CAN BE CHARGED WITHOUT
REMOVING IT FROM THE VEHICLE.
58 • Disconnect the wiring unit plug A from the
battery plug B, pressing on the sides.
59 • Connect the battery charger plug to a domestic
socket, following the attached instructions.
Connect plug B with the battery charger plug
C.
60 • When the battery is charged, detach the
battery charger from the domestic socket, then
disconnect plug C from plug B.
61 • Fully insert plug B into plug A, clicking the
plugs together.
Always remember to close and to fasten the
hood when you have finished.
BATTERY MAINTENANCE AND SAFETY
Before riding, charge your batteries for 18 hours to
initiate them. Failure to do this will result in
permanent battery damage.
CAUTION
Only adults should recharge batteries,never
children.
Never allow children to handle batteries.
Do not mix old and new batteries.
CHARGE BATTERY
• Charge the batteries no longer than 24 hours,
following the instructions enclosed with the
battery charger.
• Charge the battery, as the vehicle shows low
power, in this way you will avoid damage to the
battery.
• If you don't use your vehicle for a long period of
time unplug the battery from the main wire
harness of the vehicle. Remember to charge the
battery at least every three months.
• Never charge the battery upside down.
• Do not forget batteries during charging! Check
them periodically.
• Never use a replacement recharger or batteries
unless they are approved by PEG PEREGO.
• Batteries are sealed and maintenance free.
• Battery polarity must be observed when
connecting battery to wiring.
WARNING
• BATTERIES CONTAIN TOXIC AND CORROSIVE
SUBSTANCES. DO NOT TAMPER WITH THEM.
• Batteries contain an acid-based electrolyte.
• Do not make direct contact between battery
terminals, as this can cause an explosion or fire.
• Charging produces explosive gases. Charge
batteries in a well ventilated area away from
sources of heat and flammable materials.
• Exhausted batteries are to be removed from the
vehicle.
• Do not place the batteries near clothing to avoid
damage.
• Use only the recommended type of batteries and
storage batteries, or the equivalent.
IF A LEAK DEVELOPS
Shield your eyes. Avoid direct contact with the
electrolyte, protect your hands.
Place battery in a plastic bag and follow directions
listed below.
IF ELECTROLYTE COMES IN CONTAC WITH SKIN OR
CLOTHING
Flush with cool water for at least 15 minutes.
See a physician at once.
IF ELECTROLYTE IS INJESTED
Rinse your mouth and spit.
See a physician at once.
DISPOSAL OF BATTERIES
Help protect the environment!
Do not throw used batteries in your regular, house
hold trash.
Dispose of the old batteries in an approved
dumping station; contact your local environmental
protection agency office for further information.
CAUTION AA 1,5 VOLT BATTERY
The insertion of batteries must only be carried out
or supervised by adults. Do not let children play
with the batteries.
• The batteries should be replaced by an adult.
• Use only the type of battery specified by the
manufacturer.
• Respect the polarity +/-
• Do not allow the batteries to be in contact with
metal parts (risk of fire or explosion).
• Always remove the batteries if the toy is not in use
for a long period.
• Do not throw batteries on the fire.
• Never attempt to charge batteries that are not
rechargeable.
• Remove dead batteries from the toy.
• Dispose of dead batteries into containers
provided for the recycling of dead batteries.
VEHICLE MAINTENANCE AND SAFETY
This product conforms to EN 71 and conforms to EN
50088 safety standard for electric toys.
This vehicle is not intended for use on streets,
around traffic or parked cars.
MAINTENANCE AND CARE
• Regularly check the conditions of the vehicle,
particularly the electrical system, the plug
connections, the covering caps and the charger. In
case of fault, do not try to use the vehicle and the
charger. For repair use only original PEG PEREGO's
spare parts.
• PEG PEREGO assumes no liability if the electrical
system is tampered with.
• Do not leave vehicle or batteries near sources of
heat such as radiators, stoves, fireplaces, etc.
• Protect vehicle from water, rain, snow, etc. Do not
ride in loose sand or mud as these substances will
cause premature failure of switches, motors and
gears.
• When operating in overload conditions, such as
soft deep sand, mud or rough uneven terrain, the
overload circuit breaker will automatically
disconnect the power. After 10 or more
seconds,the circuit breaker will automatically
reset, howevere you must eliminate overload
conditions to resume normal driving.
• Periodically lubricate (with a light weight oil)
moving parts, such as wheel bearings, steering
linkages, where they rotate or touch one another.
• The vehicle's surface can be cleaned with a
dampcloth. Do not use abrasive cleaners. The
cleaning must be carried out by adults only.
• Never disassemble the vehicles mechanisms or
motors unless authorized by PEG PEREGO.
Conforms a EN 50088
Recargeable battery 6V 4,5Ah sealed lead-acid
battery.
One 60W motor
SAFETY
WARNING! THE CAR MUST BE USED UNDER ADULT
SUPERVISION.