Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Overload Protection: 1200A for 60 seconds maximum.
Frequency range: 50Hz to 60Hz.
RESISTANCE
Range
200Ω
2000Ω
CONTINUITY
Range
If continuity exists (about less than 20W), built-in buzzer will
9.
REPLACING THE BATTERY
WARNING
Before attempting to open the case of battery, always be sure that test leads
have been disconnected from measurement circuits. Close case and tighten
screws completely before using the meter to avoid electrical shock hazard.
If "
", appears on display, it indicates that the battery should be
replaced. Use the following procedure to replacing the battery:
1. Disconnect test leads from any live source and remove the test leads from
the input terminals of the meter. Push the POWER switch to OFF,
2. The battery cover is secured to the bottom case by a screw. Using a
screwdriver, remove the screw from the battery cover and remove the battery
cover.
3. Remove battery and replace with a new equivalent 9 volt battery.
4. Replace the battery cover and reinstall the screw.
10. ACCESSORIES
• Operator's instruction manual
• Set of test leads
• Gift box
• 9 volt battery. NEDA 1604 6F22 006P type.
Resolution
0,1Ω
1Ω
KPS-PA10 • Digital clamp meter
Accuracy
±1,0% of reading ± 3 digits
±1,0% of reading ± 3 digits
Description
sound.
16
Publicité
Table des Matières
