KPS -PA10 Manuel D'instructions page 13

KPS-PA10 • Digital clamp meter
CLAMP METER LAYOUT
7. OPERATING INSTRUCTIONS
DC Voltage measurement
1 Connect the red test lead to the "V" jack and the black lead to the "COM" jack.
2 Set rotary switch at desired 1000V position.
3 Connect test leads across the source or load being measured.
4 Read voltage value on the LCD display along with the polarity of the red lead
connection.
AC Voltage measurement
1 Connect the red test lead to "V~" jack and the black test lead to the "COM"
13