Phoenix Mecano Lambda Colonne Notice D'assemblage page 45

7.3 mportant information on installation and putting into operation
I
It is essential that you note and observe the following instructions. Otherwise, people
may be injured or the lifting column or other components may be damaged.
•
This lifting column must not have additional drilled holes.
•
This lifting column must not be used for outside operation.
•
The lifting column must be protected against moisture penetration.
•
This lifting column must only be used in surroundings that correspond with the IP protection
class specified on the rating plate.
•
When fixing bear in mind that the stand surfaces and contact surfaces must completely rest
on a metal surface that is at least 5 mm thick.
•
After setting up and putting into operation, it is essential that the plug of the power supply is
freely accessible.
•
You must not open the lifting column. Observe the safety information attached to the lifting
column.
•
The user must ensure that there is no danger when the power supply is active.
•
When designing tables, etc. take care to avoid crushing and shear points. These must be
respectively secured and marked.
•
Possible failure of limit switches must be considered in the construction. The relevant stop
positions must be set up as required. Particularly in the case of overhead mounting or if there
is tensile load, an external extension safeguard must be provided.
•
Automatic start-up of the lifting column due to a fault is to be stopped immediately by
disconnecting the power supply.
•
Observe the details in the assembly instructions of the accessories.
7. Life phases
45