Declaration Of Incorporation; Lambda Colonne Declaration Of Incorporation - Phoenix Mecano Lambda Colonne Notice D'assemblage

1.1 Lambda Colonne Declaration of incorporation

As set out in Machinery Directive 2006/42/EC, Annex II, 1.B for partly completed machinery
The manufacturer
Phoenix Mecano Komponenten AG
Hofwisenstrasse 6
CH-8260 Stein am Rhein
confirms that the named product
Product/manufacture:
Project number:
Trade name:
Function:
complies with the requirements for partly completed machinery in accordance with EC Machinery
Directive 2006/42/EG.
The following basic requirements of Machinery Directive 2006/42/EC are fulfilled:
1.1.5, 1.3.2, 1.3.3, 1.3.4, 1.3.7, 1.3.9, 1.5.1, 4.1.2.1, 4.1.2.3
Moreover, we declare that the special technical documents have been created according to
Appendix VII Part B.
The manufacturer declares explicitly that the partially completed machinery meets all the relevant
provisions of the following EC directives and ordinances:
2011/65/EU
Sources for the applied harmonised standards according to article 7, paragraph 2:
EN ISO 12100:2010-11
The person in the community that is authorised to compile the
relevant technical documents:
Michael Amon
RK Rose+Krieger GmbH
Potsdamer Str. 9
DE - 32425 Minden
Authorised representative:
RK Rose+Krieger GmbH
Potsdamer Str. 9
DE - 32425 Minden
Lambda Colonne
See type plate label
Lambda Colonne
Electro-motorised extracting and retracting of the inner profile to produce
a linear movement
Directive 2011/65/EU of the European Parliament and of the Council of
8 June 2011 on the restriction of the use of certain hazardous substances
in electrical and electronic equipment.
Published in L 174/88 from 01/07/2011
Safety of machinery – General principles for design – Risk assessment and
risk reduction (ISO 12100:2010)

1. Declaration of incorporation

31