Load Distribution; Installation; Tightening Torques - Phoenix Mecano Lambda Colonne Notice D'assemblage

7. Life phases

7.3.6 Load distribution

A small example: you are building a table with four lifting
columns. Each lifting column can bear 1000 N. Thus, the
lifting columns together must bear a load Fmax = 4000 N, if
the load is symmetrically in the centre of the table. If the load
moves into a corner of the table, then the lifting column has
to bear almost the entire load of 4000 N under this corner.
This would inevitably lead to overload. Even at the planning
stage of your application, pay attention not only to the total
load, but also the load on the individual lifting columns.

7.4 Installation

Anchoring bores for M8 threaded bolts for installing the lifing column are located in the push rod
and fixing plate motor side. The fixing screws are not included in the delivery.
The tightening torques to be observed can be obtained in the chart in chapter 7.4.1.
For guaranteed rigidity, it is essential to stipulate an adequately dimensioned foundation to
absorb the stated maximum compressive and tensile forces and the torque loading.

7.4.1 Tightening torques

Torque guideline values for metric shaft screws according to DIN EN ISO 4762 at 90% percent use
of the 0.2% expansion limit, for a coefficient friction of 0.14.
Dimension
M4
M5
M6
M8
M10
Pay attention to the information in the assembly instructions for the accessories. This contains
information for installing your application.
48
Strength 8.8
Tightening torque M (Nm)
A
3.0
5.9
10
25
49
Wrong
160
145
Strength 10.9
Tightening torque M (Nm)
A
4.4
8.7
15
35
72
Right
10
4x Ø 9
Strength 12.9
Tightening torque M (Nm)
A
5.1
10
15
43
84