Bestway 53377 Notice D'utilisation page 6

1
Fold all pieces of the water park toward the
center. Note: If bottom surface is still moist,
allow it to air dry prior to folding.
3
Slip the carrying bag over the rolled-up inflatable
park. Flip the bag and the park over, close the bag,
and store the park and the blower in a dry place.
To extend the life of the water spraying hose
assembly, store it in a adequately ventilated area.
Do not store them together with the park.
Repair Patch Instructions
Replace defective parts in accordance with the instructions.
Please keep for future reference.
1
Troubleshooting
PROBLEM
Motor won't run
Motor runs but wheel makes a scraping
noise
Motor is unable to run normally
2
correct
or
incorrect
CAUSE
1. Switch not turned on.
2. The circuit is opened or it is poor contact.
3. Electric capacity is damaged.
4. Choked up by hard objects.
1. Screws on the vaned wheel are loose.
2. Foreign objects in air-blower.
1. The voltage is unstable.
2. Motor is affected with damp.
3. Electric capacity is failure.
4. The impeller is loose.
6
2
Roll up the water
park tightly and
compress the fabric
to expel all of the
remaining air.
1.Defalte the item, clean the area and allow to dry thoroughly.
2.Cut a portion of the patch to the size needed and round the
corners.(See Fig.1&2).
3. Apply the repair patch:
Option #1: Using the vinyl patch.
Remove the adhesive backing from the patch material, position
the patch over the damaged area and smooth out any bubbles.
Option #2: Using the fabric patch and the glue (not included).
Apply only the amount of glue(not included) needed to cover
the repair site and press patch firmly over the puncture.
4.Allow to sit for 30 minutes before re-inflating.
Warning
: Repair patched must be applied by an adult only.
Keep out of children.
Note: Do not place
the water spray
tubing inside the
water park when
rolling it up