Setup Instruction - Bestway 53377 Notice D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Fall height in millimeters from which a life-threatening head injury would not be expected

Type of material

Double shredded bark mulch

Wood chips

Fine sand

Fine gravel

However, it should be recognized that all injuries due to falls cannot be prevented, no matter what surfacing

material is used.

It is recommended that a shock absorbing material extend a minimum of 1800mm in all directions from the

perimeter of stationary equipment such as climbing frames and slides. However, because children may

deliberately jump from a moving swing, the shock absorbing material should extend in the front and rear of a

swing a minimum distance of twice the height of the pivot point measured from a point directly beneath the

pivot on the supporting structure.

This information is intended to assist in comparing the relative shock-absorbing properties of various

materials. No particular material is recommended over another. However, each material is only effective

when properly maintained. Materials should be checked periodically and replenished to maintain correct

depth as determined necessary for the equipment in question. The choice of a material depends on the type

and height of the playground equipment, the availability of the material in a particular area, and its cost.

This information has been extracted from the CPSC publications "Playground Surfacing — Technical

Information Guide" and "Handbook for Public Playground Safety".

DISPOSAL

Waste electrical products should not be disposed of with household waste. Please recycle where

facilities exist. Check with your local authority or retailer for recycling advice.