Speedaire 35WC40 Instructions D'utilisation Et Manuel De Pièces page 20

TROUBLESHOOTING GUIDE FOR UNITS IN SERVICE FOR A PERIOD OF TIME (CONTINUED)
Symptom
Oil in discharge air
18
Possible Cause(s)
1. Restricted intake filter
2. Wrong type of oil
3. Worn rings or scored cylinder
4. Compressor running hot
Corrective Action
1. The filter should be changed frequently to avoid
possible problems and to make the compressor
operation efficient. There is a vacuum created in
the intake of the compressor, which causes high oil
consumption by pulling oil through the rings. There
is also a chance of the intake filter media being
destroyed, allowing contaminants to enter the intake
and cause wear problems
2. Do not use SAE-30 automotive type oil. Using the
wrong oil can cause various problems with the pump
and will void the warranty. Only use the oils that the
operating manual recommends
3. Replace rings and/or replace cylinder
4. Make sure compressor is running the correct rotation.
Compressor should be clean and in a well ventilated
area. Oil should be changed on regular intervals
according to the specifications listed in the manual.
Air filter must be changed as it gets dirty