Talon MINN KOTA 2994153 Manuel Du Propriétaire page 5

INSTALLING THE TALON FOOT SWITCH
Your new Talon Foot Switch comes complete with all of the hardware you'll need to install it directly to the deck of your boat. Please
review the parts list, mounting considerations and tools needed for installation prior to getting started.
INSTALLATION PARTS LIST
Item /
Part # Description
Assembly
A 2994153 ASSEMBLY, TALON 3 FT SWITCH
2 2383455 SCREW-#8 X 1.0" PPH TY AB SS
4 QUICK REFERENCE GUIDE
s
6 INSTALLATION INSTRUCTIONS
s
This part is included in an assembly and cannot be ordered individually.
✖
Not shown on Parts Diagram.
s
MOUNTING CONSIDERATIONS
Before mounting your Talon Foot Switch, please give consideration to the following:
1. Examine your boat to ensure that you will not drill into any obstructions and that the hardware will be accessible for assembly.
2. Make sure the area under the mounting location is flat, clear to drill holes and that the installation hardware will not damage
existing components below the mounting surface. It may be necessary to shim or modify the mounting surface under the mounting
location to create a flat area for the Foot Switch Pedestal to be mounted.
3. Mount the Talon Foot Switch in an area that has a clear line of communication with the Bluetooth enabled Talon(s) it is intended to
control for optimum performance.
4. Mount the Talon Foot Switch in an area where it will not become a tripping hazard.
TOOLS AND RESOURCES REQUIRED
• Pencil or similar marking tool
• Drill
©2018 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION
Qty.
1
3
1
1
• #2 Phillips Driving Bit
A
2
minnkotamotors.com | 5