Talon MINN KOTA 2994153 Manuel Du Propriétaire page 16

PAIRING A FOOT SWITCH TO A SINGLE TALON
CLEARING PAIRED TALONS FROM THE FOOT SWITCH
The Foot Switch was designed so that all paired Talons can be cleared from memory.
1
a. Press and hold the Up
button on the Foot Switch at the same time until all
of the LED's at the top of the Foot Switch begin to
scroll. Then release the buttons. The Foot Switch will
go into Pairing Mode for 20 seconds. Once Pairing
times out all Talons will be cleared.
NOTICE:
Putting the Foot Switch into Pairing
Mode, even if it is accidental, without Pairing the
Foot Switch to a Talon will clear all paired Talons.
16 | minnkotamotors.com
button and the Down
Anchor Mode
Selection LED
Auto Up Button/
Pairing Button
Talon Foot Switch
Talon Selection
Indicator LEDs
Auto Down
Button/Pairing
Button
©2018 Johnson Outdoors Marine Electronics, Inc.