Toggle the Mode from the Foot Switch
Toggle the Mode on the Foot Switch when the water or anchoring conditions change to fit your anchoring needs.
1
a.
The Mode can be toggled from the Foot Switch by
selecting the Anchor Mode
Mode Selection LED displays the Mode that the
Talon is currently set to. Press the Anchor Mode
button to toggle to the desired Mode.
b.
When the Talon is put in Standard mode, the LED
will flash red and green and then turn off. When the
LED is Green, the Talon is in Soft Bottom Mode.
When the LED is Red, the Talon is in Rough Water
Mode.
NOTICE:
When the Talon is paired with a second
Talon, pressing the Anchor Mode
Talon will toggle the Mode for both Talons.
Control the Work Light with the Foot Switch
The Work Light at the top of the Talon can be either white or blue and toggled between high, medium, or low intensities.
1
a.
To Toggle the Work Light "on", press and hold the
Talon Selection
the top of the Talon turns "on".
b.
Continue to press the Talon Selection
the Foot Switch again before 5 seconds passes until
the desired color and intensity is selected.
c.
To toggle the Work Light "off" press and hold the
Talon Selection
turns "off".
NOTICE:
When the Talon is paired with a second
Talon, pressing and holding the Talon Selection
button will toggle the light for both Talons. The six
intensities for the Work Light are white high, white
medium, white low, blue high, blue medium and
blue low.
©2018 Johnson Outdoors Marine Electronics, Inc.
button. The Anchor
button on the
button until the Work Light on
button on
button again until the Work Light
USING THE FOOT SWITCH
Anchor
Mode Button
Talon Foot Switch
Talon Foot Switch
WARNING
The Work Light on the Talon is not intended for navigational
purposes. The Work Light does not replace or act as a
substitute for proper navigation lighting of your vessel. Failure
to properly light your boat may cause harm or serious injury.
Anchor Mode
Selection LED
Talon Selection Button/
Work Light Button
minnkotamotors.com | 13