Kärcher G 2700 R Mode D'emploi page 7

Illustration 1:
Attach the handle to the pressure washer
frame.
Illustration 2:
Align holes, insert bolts (B), and tighten with
knobs (A).
Illustration 3:
Place the quick connect nozzles (E) in the
nozzle holder.
STEP 1:
Pull the spring-loaded collar of the wand back
to insert your quick connect nozzle choice.
Release the collar and push the nozzle until
the collar clicks.
CAUTION
High pressure in nozzle area.
Risk of injury caused by improperly locked
nozzle.
Make sure you hear a "click" when inserting
n
the nozzle tip in to the wand.
Pull the nozzle to make sure it is seated
n
properly before operating your unit.
STEP 2:
Attach the high pressure hose (C) to the trigger
gun (D).
Assembly
OPERATING INSTRUCTIONS
Illustration 4,5:
Attach the wand (F) to the spray gun (D).
Push the wand (F) into the trigger gun (D) and
then thread the connection.
Illustration 6:
Remove the cap / dipstick from the oil level
and add the oil.
CAUTION
Engine shipped without oil. Before starting
engine, fill with oil. Do not over-fill. Do not
run the engine with a high or low oil level as
this can cause engine damage.
If you have further questions regarding the
engine, please refer to the engine manual
included with the unit.
STEP 3:
Check oil level. Oil level should always be
between the "FULL" and "ADD" or "MAX" and
"MIN" marks on the dipstick as shown in the
picture below.
ADD / MIN
Be sure the machine is level when checking
the oil level. (Refer to the engine operating
manual for seasonal grades).
We recommend to change the oil after the first
5 hours of use, then once every 50 hours.
STEP 4:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
Do not add oil to the gasoline.
FULL / MAX
English 7