Maintenance And Cleaning - Oase Waterfall Illumination Notice D'emploi

Installation
Sensitive electrical components.
Possible consequences: The device will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
How to proceed:
 B, C
1. Plug the holders onto the light rail.
– Do not mix up the right and the left holder.
2. Place the light rail into the source bed of the waterfall from above. Ensure that the holders are correctly placed in the
source bed.
3. Install the transformer at a minimum safety distance of 2 m from the water.
4. Connect the connection cord of the unit to the safety transformer.
Commissioning/start-up
Switching on the unit: Plug the power plug of the transformer into the socket. The unit switches on immediately.
Switching off the unit: Disconnect the transformer power plug.
Remedy of faults
Malfunction
LEDs are not lit
Wear parts
Bulbs are wearing parts and are excluded from the warranty.

Maintenance and cleaning

If necessary, clean the unit with clear water using a soft sponge or cloth.
Storage/Over-wintering
Remove the unit at temperatures below zero degrees centigrade. Thoroughly clean and check the unit for damage.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
Cause
No mains voltage
Supply cable defective
Transformer defective
Light rail defective
Remedy
Check mains voltage
Check supply lines
Replace the attendant unit
Replace transformer
Replace unit
- EN -
9