IKEA STJARNSTATUS Mode D'emploi page 12

DOOR REMOVAL
To reinstall the refrigerator
doors:
IMPORTANT
When replacing the doors on the lower
hinge, they must be installed at a 90
degree angle.
1 Replace the lower hinge screws.
2 Holding the door at a 90 degree
angle, drop the pin down into the
center hinge opening. Rotate it
slightly in either direction until the
door falls down into place.
Doors
at 90º
3 Reinstall top hinge.
4 Insert the water line in the top left
tunnel pushing from the front to the
back of the unit.
Insert
tube up
to the
marking
line
Press
Press
Water
Line
12
Pin
Mechanism
(Door Bottom)
Bottom
Hinge
Opening
Water
Line
Note
When reinserting the water tube and
replacing the top hinge cover, use care
to be sure you do not kink the tube.
Note
Upon replacement, the tube needs to
be fully inserted up to the marking
line.
5 Reconnect the harnesses.
6 Replace the top hinge covers.
7 Reconnect electrical power cord to
the wall outlet.
To reset door pin:
If doors are removed at less than a 40
degree angle, the pin returns to the
home position. It can be reset by turning
the door upside and using a 5/32" Allen
wrench to rotate the left hand pin 90
degrees clockwise and the right hand pin
90 degrees counterclockwise.
For
RIGHT DOOR,
turn pin 90˚
counter-
clockwise
Once the door pins are reset, follow the
steps "To reinstall the refrigerator doors".
EN
For
LEFT DOOR,
turn pin 90˚
clockwise