Baja motorsports AT150SSC Manuel Du Conducteur page 28

CAUTION:
Failure to remove the rags or wrapping from the exhaust
pipe could result in failure of the exhaust system.
 Remove the drain plug from the air filter box to allow any
standing water to drain. Replace the drain plug when
draining is finished.
 Lubricate according to General Lubrication section.
 Follow the procedures in Pre-Ride Inspection to check
the unit for any problems that may have occurred during
your last ride.
 After washing your ATV, test your brakes by riding at a
slow speed. If necessary, apply brake several times to let
the friction dry out the brake linings. Wet brakes may not
provide as much stopping power as dry brakes.
WARNING:
Operating the ATV at high speeds when the brakes are
wet could result in serious personal injury.
STORING THE ATV
If you do not use the ATV for a long time, it will need special
service requiring appropriate materials, equipment, and skill.
For this reason, we recommend you trust this maintenance
work to an authorized service center. If you wish to service the
machine for storage yourself, follow the general guidelines.
VEHICLE:
 Place the vehicle on level ground.
 Wash the vehicle.
© 2010 Baja, Inc. All Rights Reserved.
MAINTENANCE
FUEL:
 Drain the fuel from the fuel tank using a hand pump.
 Drain the fuel from the carburetor by releasing the carbu-
retor drain screw.
TIRES:
 Inflate the tires to the normal pressure.
NOTE: Tire pressure should only be measured or
adjusted when tires are cold.
Check the tire pressure carefully while inflating. Too much
air in the tire could cause the tire to burst, causing serious
personal injury.
Maintaining correct air pressure in the tires is very impor-
tant. Too little pressure could allow the tire to rotate off
the wheel rim. Too much pressure could cause the tire to
burst. Failure to maintain correct air pressure in the tires
could cause problems with vehicle operation and stability,
causing serious personal injury.
EXTERNAL:
 Spray all vinyl and rubber parts with rubber protection.
 Spray unpainted surfaces with rust preventative.
 Coat painted surfaces with car wax.
PROCEDURE FOR RETURNING VEHICLE TO SER-
VICE:
 Clean the entire vehicle.
 Make sure the vehicle is properly lubricated.
 Perform the Pre-Ride Inspection as listed previously.
28 — English
Recommended Pressure
3.6 psi ± 0.5 psi
(25 kPa ± 3.5 kPa)
WARNING:
WARNING: