Carefully pour fuel into the tank until the level reaches the
bottom of the filler neck. Avoid spillage.
Replace fuel tank cap and turn clockwise to secure.
WARNING:
Check for fuel leaks. A leaking fuel cap is a fire hazard and
must be replaced with an original manufacturer's replace-
ment cap immediately. If you find any leaks, correct the
problem before using the product. Failure to do so could
result in a fire that could cause serous personal injury.
WARNING:
Overfilling the fuel tank could be hazardous. If you overfill
the fuel tank, fuel may overflow when it expands due to
heat from engine or sun. Spilled fuel could catch fire or
explode, resulting in serious personal injury.
WARNING:
Failure to complete the pre-ride inspection and verify
proper performance of the ATV before riding can result
in serious personal injury.
PRE-RIDE INSPECTION
ITEM TO
ITEM MUST PERFORM AS
CHECK
FOLLOWS:
Steering
Smoothness; no restriction of move-
ment; no play or looseness.
Brakes
Proper brake lever free play; enough
brake force; parking brake effective-
ness.
Tires
Proper air pressure; enough tread depth;
no cracks, rips, or other damages.
Fuel
Enough fuel for the intended trip.
Fuel cap
Fuel vent hose installed properly; no
damage to fuel tank or cap; fuel tank
cap closed securely.
Engine stop
Proper operation of switch. Start engine,
switch
then press stop switch. Engine should
stop.
Engine
Proper level; check lubricant by inspect-
lubricant
ing engine oil dip stick. The engine lu-
bricant should be between the minimum
and maximum lines.
Throttle
Proper free play of throttle lever; smooth
response; quick return to idle position.
General
Bolts and nuts are tight; no rattle from
condition
any parts of the engine when running;
no visible evidence of damage including
frame cracks.
OPERATION
STARTING THE ENGINE
WARNING:
Be sure to set the parking brake before you start the en-
gine. The ATV could move unexpectedly as soon as you
start the engine, causing you to lose control of the ATV.
Properly position yourself on the ATV seat.
Set the front or rear parking brake.
Turn the fuel valve to the ON position.
Turn the switch key to the ON position.
Set the engine stop switch to the RUN position.
Press the START button to start the engine. If the battery
is dead, use the pull cord (if equipped) to start the engine.
This ATV has an automatic choke. Keep the throttle lever
slightly depressed and allow the engine to warm up com-
pletely before attempting to ride.
When you are sure the engine is warm, release the park-
ing brake.
Release the brake lever and open the throttle gradually
to move forward.
WARNING:
Always open the throttle gradually when you want to ac-
celerate. Opening the throttle suddenly could cause the
front wheels to leave the ground and cause loss of control
of the ATV causing serious personal injury.
WARNING:
Always keep both hands on the handlebars and both feet
on the foot rests of your ATV during operation. Removing
even one hand or foot can reduce your ability to control
the ATV or could cause you to lose your balance and fall
off the ATV. If you remove a foot from the foot rest, you
may come in contact with the ATV, ground, obstacles,
etc., which could cause an accident and result in serious
personal injury.
REVERSING
This ATV does not have a reverse gear. If you need to reverse
the direction of the unit, you will need to follow the instruc-
tions for turning or dismount the ATV and push it backward
by hand.
WARNING:
When attempting to reverse the direction of the ATV by
pushing it, keep your hand or foot on the brake at all times
and always stay clear of the wheels. Failure to keep your
hand or foot on the brake and remain clear of the wheels
could result in serious personal injury.
13 — English
© 2010 Baja, Inc. All Rights Reserved.