Charging The Battery - Hilti SID 14­A Mode D'emploi Original

Torque
4.2 Battery, 14 V
Battery operating voltage
Ambient temperature
Storage temperature
4.3 Battery, 22 V
Battery operating voltage
Ambient temperature
Storage temperature
5 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.

5.1 Charging the battery

1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
*2153700*
SIW 22­A
1/2" square drive
with ball-notch
retention
Setting I 66 ftlb
(90 Nm)
Setting II 100 ftlb
(135 Nm)
Setting III 148 ftlb
(200 Nm)
2153700
3/8" square drive
with locking ring
55 ftlb
f
(75 Nm)
89 ftlb
f
(120 Nm)
129 ftlb
f
(175 Nm)
14.4 V
14 ℉ ... 140 ℉
(−10 ℃ ... 60 ℃)
−4 ℉ ... 104 ℉
(−20 ℃ ... 40 ℃)
21.6 V
14 ℉ ... 140 ℉
(−10 ℃ ... 60 ℃)
−4 ℉ ... 104 ℉
(−20 ℃ ... 40 ℃)
f
f
f
English 11