Replacing The Filter Cartridges En; Emptying The Dust Collecting Drawer En - Abicor Binzel xFUME PRO Mode D'emploi

9 Maintenance and cleaning
9.2 Replacing the filter cartridges
NOTICE
• Always replace all existing filter cartridges at the same time.
3)
Fig. 5 Replacing the filter cartridges
1 Switch the welding fume extraction system to "Off" using the On/Off rotary power switch (4).
 Fig. 4 on page EN-12.
2 Pull out the mains plug (no Fig.).
3 Remove the cover.
4 Remove and replace the filter cartridges.
5 Dispose of the filter cartridges in accordance with local regulations (no Fig.).
 12 Disposal on page EN-17
6 Reverse the steps above to reassemble the system (no Fig.).
9.3 Emptying the dust collecting drawer
3)
Fig. 6
Emptying the dust collecting drawer
1 Switch the welding fume extraction system to "Off" using the On/Off rotary power switch (4).
 Fig. 4 on page EN-12.
2 Pull out the mains plug (no Fig.).
3 Remove the cover.
4 Remove and empty the dust collecting container.
5 Dispose of the dust in accordance with local regulations (no Fig.).
 12 Disposal on page EN-17
6 Reverse the steps above to reassemble the system (no Fig.).
EN - 14
4)
4)
BAL.0732.0 • 2020-07-09
xFUME PRO