Program The Drive Head - tormatic W-600 Mode D'emploi

Installation
6. Power supply 24 V DC, max. 100 mA (permanent)
I - Connection for e.g. external receiver (accessory)
7. Lighting
K - Connection for external, protectively insulated lighting or signaling
lamp (protection class II, max 500W) (accessory)
Caution!
Do not connect a push button.
8. smartGarage
P - Connection for Mobility Module (accessory)
Pulse generator and external safety devices
In situations of increased requirements in terms of personal protection, we recommend, in addition to
the internal power limitation of the drive, the installation of a photoelectric sensor. Further information
on our range of accessories can be found in our sales literature. Consult your specialist dealer.
Warning label
Place the sticker clearly visible on the inner surface of the garage door.
Dismantling the operator
1. Pull out the mains plug and disconnect all existing terminals.
2. Disconnect garage door and operator. Fix garage door.
3. Proceed according to the Installation instruction poster, but in reverse sequence.

Program the drive head

This section describes the normal programming of the drive head during installation.
For further adjustments, or for special adjustments, refer to the section 'Special settings'.
38
K
230V
P
W-600