Publicité
Les langues disponibles
Les langues disponibles
Care and Maintenance of the Jurastone trim kit
Repair of minor chips and scratches
In the event of an accident, where chipping has occurred, we have provided you with a small touch-up kit to match
the trim kit. In the case of a very deep chip, a little plaster filler may be used to bring the damaged area level before
concealing the repair.
Step #1 Fill the affected area with "dabbing" strokes. A couple of coats will be needed, allowing each coat to dry
before applying the next coat.
Step #2 Apply the clear lacquer with the texture grains; one coat should be sufficient for this step.
Step #3 When all of the coats are completely dry, the surface of the damaged area should be sanded down with
a fine sandpaper to blend the repaired area with the rest of the component.
Marks and Scuffs
Most marks and scuffs can be very easily removed by using the quality eraser provided or a soft wet sponge. This
will simply rub off most marks that might occur on the trim.
Wax Removal
In the event of some hot wax is spilled on the top trim or hearth, wait for it to cool. When the wax is cool
CAREFULLY pick it off with the tip of a sharp object. When using the sharp object it is very important that the sharp
edge is not pushed into the finish of the affected area, as this will chip the finish. Use a commercial wax remover for
any remaining residues, testing the remover on an inconspicuous area of the trim prior to use on the affected area.
Spilt Liquids
Spills and stains should be removed as soon as possible for best results. Dab up spills with a clean cloth or paper
towel, avoiding wiping the spill. Water and soap will clean up most spills, providing that they are addressed quickly.
Avoid using strong acids or chemicals with a strong acid reaction, as they might roughen the surface if left on for any
length of time. It is always best to test the cleaning agent on an inconspicuous part of the trim in order to check its
impact on the finish.
Dust and air born dirt will settle on any trim surface. This can easily be removed by a vacuum with a soft bristle
head. Be careful to not scratch the surface in the process.
Because our policy is one of constant development and improvement, details may vary slightly from those given in
this publication.
190 – 2255 Dollarton Highway, North Vancouver B.C., CANADA V7H 3B1
Designed and Manufactured for/by
Miles Industries Ltd.
Tel. (604) 984-3496 Fax (604) 984-0246
www.milesfireplaces.com
© Copyright Miles Industries Ltd., 2007
3
Publicité
